25th February 1939, Page: 263, Column: 1
Electricity In Coal Mines
In the paper which Mr. R. Nelson read before the Institution of
Electrical Engineers on "Electricity in Coal Mines a Retrospect
and a Forecast" (see page 195, No. 13, Vol. 49), the Author
included some brief references to haulage, pumping, machine
mining and lighting as under :—
Haulage.
Haulage by rope, either motor-driven or engine-driven, is
practically the only method of haulage. That picturesque animal
the pit pony, which has deserved well of its time and generation,
is being slowly withdrawn from the mines. In 1913 there were
73,000 in use; in 1937 that number had fallen to 33,000, and it
may be expected that in a few years the "pit pony," sometimes
a horse 14 hands high, will have ceased his often very arduous
labours.
Locomotive haulage can rarely be applied to advantage in a
mine roadway not constructed for that method of haulage.
Gradients, which frequently vary at short intervals in the same
length of roadway, and also curve radii, and the dimensions of
the roadway, not to mention the rail bed, impose conditions which
are found to be too severe in practice. Although storage-battery
locomotives have been used from time to time, there are very few
at work to-day. Electric trolley locomotives are generally
inapplicable. In one suitable instance in an open-light mine
in Somerset consent was given by the Mines Department, but
the project did not materialise. With the possible exception of
pumping, electricity has been of no greater service to the mining
engineer than in assisting to solve the problem of the haulage of
heavy trains of coal below ground. Otherwise than by modern
electrically-driven haulage gear, it is difficult to see how the traffic
problem in a large mine could be successfully and economically
handled.
Pumping.
Historically, the first application of mechanical power was for
unwatering the Cornish mines in the early 1700's. Pumping
machinery has gone through a long process of development since
that time, during which the driven machinery has literally been
revolutionised and the driving and driven machinery have moved
from the surface of the mine, first to insets in the side of the shaft
for stage-pumping, then to the shaft bottom, and later, if required,
long distances inbye. Although there is a large number of 3-throw
ram pumps of high efficiency in use, the greater part of the 427,084
h.p. of electric motors in present use for pumping is direct coupled
to high-lift multi-stage centrifugal pumps, which are ideally suited
for electric drive. The combination of an electric motor coupled
direct to a centrifugal pump has solved an age-old problem very
cheaply and conveniently, particularly in mines where the combination
is met of heavy water feeders and greet depths from the
surface.
Machine Mining.
The growth of machine mining, especially during recent years,
has been very marked. In 1910, 16 million tons of coal, i.e.,
5.7 per cent. of the total output, was machine-cut, whereas in
1937 more than 137 million tons of coal, or 57 per cent. of the
total output, was machine-cut. Electricity and compressed air
are rival sources of power for this purpose. The use of both is
increasing, but electricity more rapidly. Of the 137 million tons
of machine-cut coal in 1937 over 97 million tons, more than 70 per
cent, of the total, was cut by electricity; but it should be mentioned
that in that same year more than 13 million tons of coal
was won by the use of pneumatic picks, to which there is no
electrical equivalent. This compares with 4 million tons in 1932.
Compressed air is also used much more extensively than electricity
for rock-drilling.
The use of mechanical conveyers underground has increased
rapidly in recent years. In 1927 there were in use 2,856 conveyors
and loaders; and 28 million tons, or 11.4 per cent. of the total
output, was mechanically conveyed for short distances at or near
the coal face. In 1937 there were 8,031 conveyors and loaders
in use, of which 60 per cent. were electrically-driven, and 123
million tons, 51 per cent. of the total output, was mechanically
conveyed. As more than one-half of the total output of coal in
1937 was machine-cut and machine-conveyed, it is obvious that
coal-cutting and coal-conveying are progressing side by side.
Their general applicability to thick as well as to thin seams of coal
is now fully recognised.
Lighting.
According to the official returns there were in 1937 some 93,000
lamps connected to distribution mains below ground. Of these
46 per cent., were used at shaft insets and sidings, 25 per cent. on
roadways, and the balance of 29 per cent. in cabins, stables, and
motor rooms. The number of lamps fed from distribution mains
in use at the coal face in 1937 was returned as 41. Altogether it
appears from the returns that, having regard to the importance of
good lighting in manual labour of all kinds, both the number of
lamps in use and the rate of growth of mains lighting below ground
are surprisingly low.
Apart from mains lighting there were in use at or near the coal
face 1,850 self-contained lighting units, each consisting of a
magneto generator driven by a small compressed air turbine.
The return of electric hand safety-lamps in use is of interest.
In 1908 fewer than 10,000 electric safety-lamps were being used,
in conjunction with 750,000 oil safety-lamps. In 1937 there were
462,402 electric safety-lamps and 177,048 oil safety-lamps in use.
The diminished total number of lamps is due to the fact that the
output of coal is now some 20 or 30 million tons per annum less
than it was in 1908, and diminished output, together with
mechanical mining, is reflected in fewer miners and therefore fewer
miners' lamps. The electric safety-lamp has so many inherent
advantages that the successful development of a gas-testing
attachment, towards which many creditable efforts have been
made, would see almost the last of the Davy lamp, which, with
its numerous improvements, has served the mining community
superlatively well for 125 years since its first invention. Though
totally irrelevant to the subject, it may be recalled that the
inventor of the Davy lamp in the course of his experiments as a
boy produced an explosion in the garret of his employer, a Penzance
surgeon. "Was there ever so idle a dog?" asked the surgeon.
"He will blow us all into the air." Amongst the hierarchy of
false prophets the Cornish surgeon must occupy a very distinguished
position.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Nelson, R. | | | |