|
17th December 1938, Page: 188, Column: 1 Igniting Coal DustHow experiments had been made to determine whether clouds of coal dust as might be produced under modern conditions of machine mining could be ignited by an electric arc and whether a flame could spread through them were described by Dr. T. S. E. Thomas and Dr. R. V. Wheeler in a paper presented at the recent general meeting of the Midland Institute of Mining Engineers. The paper stated that experiments were carried out in a steel cylinder four feet in diameter and ten feet high. The top of the cylinder was fitted with a steel ring leaving an opening two feet in diameter over which a paper cover to act as pressure release was stretched. Release of pressure from within the cylinder was also afforded three feet from the base by a vent pipe ten inches in. diameter with its end covered by a steel flap. The more important deductions from the experiments were that a dust cloud of density less than about 0.05 oz. per cubic font of air formed by fine Silkstone coal could not be inflamed by an are produced by breaking a circuit carrying the maximum power available — about 30 kw. Doubtless arcs of greater power than this could have ignited less dense dust clouds in their path, but observations suggested that the flame would have been limited to the vicinity of the arc. Two arcs formed by interrupting circuits carrying less than 2.5 kw., could not inflame the densest dust clouds tested. A series of tests was made in which the fineness of the Silkstone coal dust was varied, and it was found that so long as the proportion of "through — 200-mesh" dust did not fall below about 50 per cent., the density of dust cloud which could be inflamed by arcs of the power used did not need to be increased and was about 0.059 oz. per cubic foot of air. When nearly all the "through — 200-mesh" dust had been removed, however, the cloud had to be inflamed. It was stated in the paper that it was evident that, for the inflammation of clouds of bituminous coal dusts by electric arcs, as by other means, a density of not much less than 0.05 oz. per cubic foot of air was necessary. The density of dust clouds formed during coal mining had been and was being carefully studied.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||