23rd March 1938, Page: 292, Column: 2
White Diamonds In Drilling
At the meeting of the Institution of Mining and Metallurgy on
17th March a paper on "Some Recent Developments in Diamond
Drilling Practice" was presented by Karl Sundberg and
Olof Lindquist. They explained that with the increased use of diamond
core drilling since its first application in 1867, the difficulty of
purchasing carbons suitable for diamond drilling has also increased,
and the price of carbons rose from 10s, per carat in 1870 to approximately
£35 per carat in 1929. Manufacturers and purchasers of
diamond drills have therefore tried to find a substitute and have
tested other kinds of diamonds as well as other abrasives. After
experiments extending over several years, white diamonds (bort)
were found satisfactorily to replace carbons in drilling bits, and
during the last ten years carbons have been more and more
replaced by bort.
Hard metals, and among them chiefly tungsten carbide, have
also proved to be valuable abrasives for drilling. Their hardness
is, however, less than that of diamonds, and hard-metal bits can
so far only be used for drilling in rather soft rocks. Diamonds are
still the superior and more economical abrasive for drilling in
hard rocks.
It is very difficult to define the expression "hardness." It
has to be understood as the sum of different functions of destructibility
and rigidity of the atomic grid. As the diamond in Mobs'
scale is assumed to be the hardest material, No. 10, one gets the
impression that all diamonds are of the same hardness, which,
however, is not true.
The difference in hardness between the different kinds of
diamonds is not large, but it is an interesting fact that carbon has
the lowest value, 9.82. This agrees with the authors' practical
experience. Several authors assert that carbons are the hardest
and therefore the most suitable diamonds for drilling. This
assertion has not been proved and is probably due to a confusion
of hardness and toughness.
The carbon is composed of very small diamond crystals and
amorphous carbon or graphite, whereas the white diamond (bort),
except ballas, is generally built up of one single crystal. The
white diamond can easily be split along three planes and is consequently
more brittle and less tough than the carbon.
It is generally assumed that the carbon bits set with a few
carbons each of ¾ to 1½ carat give the most economical results at a
speed of 150 to 200 r.p.m. When bort was first used for core
drilling instead of carbons, the stones were set in the bits in the
same way as carbons and the drills were operated at the same
rotating speed as before. Later, however, it was discovered that
this was not the way to get the most out of the bort.
In order to discover how bort should best be applied for drilling,
the Swedish Diamond Rock Drilling Co. has carried out a number
of tests with different bits and under different conditions, of
general interest to all those concerned in diamond drilling. These
and other tests have resulted in an increase of the number of
diamonds used as well as in a higher rotating speed of the drilling
machines.
The diamond drilling cost is substantially composed of the cost
of labour and the cost of diamonds. The labour cost decreases
with increased drilling speed. The cost of diamond wear may,
on the contrary, increase by drilling too fast. The main object
of the investigations has been to find a bit which combines high
efficiency with little diamond wear.
Following examination of laboratory and field tests the Authors
say it is evident that hand-set bits are going to be replaced by
machine-set bits with many small diamonds.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Lindquist, Olof | | | |
| Sundberg, Karl | | | |