26th March 1938, Page: 291, Column: 1
Mersey Tunnel Ventilation
At the March meeting of the Manchester Geological and Mining
Society Mr. J. R. D. Walker, B.A., read a paper on "Some
Features of the Ventilation of the Mersey Tunnel." He explained
that the tunnel is ventilated by 30 fans with a total capacity of
10,016,000 cubic feet per minute. The capacity of the individual
fans varies from 92,000 to 641,000 cubic feet per minute. Only
half the fans, however, are in use at any one time, so that 100 per
cent, standby is available. Each fan is driven through a hydraulic
coupling which gives speed control from zero to full speed. The
loss of speed and power in the couplings is about 3½ per cent. at
full load. The wasted power, however, increases as the slip in
the coupling is increased, and in the interests of economy each
motor was wound to run at two speeds. In each case No. I fan
motor is wound for full speed and two-thirds speed, and No. 2
fan motor for full speed and half speed. Thus by using the
appropriate fan the losses can be kept quite small. The volume
of air passing is proportional to the speed of the fan, but the
horse-power to the cube of the speed. Thus it is desirable to run
the fan at the least permissible speed consistent with adequate
ventilation. The saving in power at the fan shaft resulting from
a reduction in speed far outweighs the extra losses in the hydraulic
couplings. The fan speed is regulated primarily by selecting the
appropriate motor winding, and secondarily by adjusting the
amount of oil in the hydraulic couplings. All these operations
are normally performed by contactor gear operated by remote
control from the central control room.
In order to show the operator in the central control room
precisely what is the condition of the ventilation at any time,
instruments have been provided to indicate and record the speed
of each fan, the air flowing in each duct, the amount of CO present
in the exhaust air at the various exhaust shafts and the clearness
of the air at various points in the tunnel. Carbon monoxide is a
highly poisonous gas and is produced freely by petrol engines,
owing to incomplete combustion of the fuel. The amount of CO
produced varies considerably with the type and condition of the
engine, and the quality of the fuel. The more efficient the
combustion the less is the proportion of CO, and it is interesting to
observe that the CO produced by English cars and lorries is less
than that produced by American automobiles. The flue gases
from a steam wagon contain a great deal of CO. The exhaust
fumes from a diesel engine do not contain any CO and are not
poisonous, although if sufficiently concentrated they have a mild
laxative effect.
The most dangerous feature of CO is that, being colourless,
odourless and tasteless, and as the symptoms of CO poisoning are
not very distinctive until a considerable degree of intoxication is
reached, it is not readily detected. CO detectors were therefore
installed in duplicate at each exhaust shaft, and were arranged to
indicate in the ventilation building, to transmit a continuous
record to the central control room, and to ring alarm gongs in both
places should the CO rise above 3 parts in 10,000. A considerably
higher proportion of CO could be allowed for a short time, without
injury to the tunnel staff. The harmful effects depend both on
the concentration of the gas and on the length of time available
for the gas to be absorbed. Consequently the tunnel staff are
more susceptible to the gas than are the persons merely driving
through. A concentration of 12 parts in 10,000 for an hour is
as much as can normally be borne without ill effects. In practice
the concentration is usually about 1 part in 10,000, although
during exceptional traffic peaks it may record 2 or 3 parts for a
short time.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Walker, J. R. D. | | | |