|
26th February 1938, Page: 266, Column: 1 Incombustible Dust ProblemsAt the last meeting of the Mining Institute of Scotland, during the discussion of the paper by Dr. J. Smellie and Professor A. M. Bryan, B.Sc., on "The Efficiency of Incombustible Dust in the Prevention of Coal Dust Explosions," Professor Bryan replied to some points raised. He said that "If the quantity of coal dust (of average inflammability), sufficient to form a layer of 1/500th part of an inch thick on the roof, floor and sides of a roadway, were raised into suspension on a roadway 50 feet square in cross-section, it would produce a cloud of sufficient density to propagate flame." There is no doubt, he proceeded, that an explosion raised a considerable amount of dust, but how much of this is only surface dust swept off a large area of roadway, it is difficult to tell. The Authors' experiments indicated that a layer of dust several inches thick could be no more effective in the early non-violent stages of the explosion than a layer of dust, say, only ½ inch thick, despite possibly every reassuring dust analysis. In other words, only the loose surface dust might rise and be dispersed. With regard to a more definite method of sampling, the feeling of the Authors is that it will be difficult in practice to create a violent agitation in an underground roadway and then to collect a representative sample of the dust dispersed by the violent agitation. They have suggested the use of a suction device which would take only that dust which was easily moved from the surface of any dust deposit. The depth to which the sample should be collected would depend upon the depth an explosion could affect, particularly in its initial stages. If high percentages of incombustible matter were to be obtained by this method of sampling, very frequent applications of incombustible dust would be necessary, or very frequent mixing of the dust deposits would be required where the incombustible dust was deposited in large quantities at infrequent intervals. The Authors have no information on the effects of high-speed main-and-tail empty sets on the dust conditions in roadways, but they think such sets must set up violent local eddying or swirling which would not only raise roadway dust into suspension, but would also add appreciably to the amount of coal dust in suspension and, eventually, in the roadway deposits.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||