4th December 1937, Page: 164, Column: 1
Detonation In Solid Explosives
Cameras for Measuring
The determination of the rate of detonation in coal mining
explosives is important from the points of view of both safety
and utility. This is the opening statement in Safety in Mines
Research Board Paper No. 99 by W. Payman, W. C. F. Shepherd,
and D. W. Woodhead, on "High-speed Cameras for Measuring
the Rate of Detonation in Solid Explosives" (H.M. Stationery
Office, 2s. net). The measurement is usually carried out by the
well-known methods of Mettegang or of Dautriche; for the
former, a length of 1 metre of explosive is usually required, and
for the latter a length of about 20 cm. A method for which
cartridges only a few centimetres long are needed was devised by
Jones, Each of these methods suffers from the disadvantage
that the rate of detonation recorded is an average velocity between
two points, and no indication is given as to whether or not a
uniform rate has been established. This objection may be overcome
by the use of a photographic method, most often with a
rapidly revolving film, as applied to explosives by Laffitte in
France, by Perrott and Gawthrop at the Bureau of Mines in the
United States of America, and by Jones, working for the Explosives
in Mines Research Committee.
In Paper No. 99 two high-speed cameras are described which
employ methods for obtaining high writing speeds without fear
of distortion or rupture of the photographic film. The first, the
"internal-drum camera," makes use of a high-speed revolving
drum with the film on the inside of the rim so that the effect of
centrifugal force is to press the film against the machined inner
face of the rim. The second is a "rotating-mirror camera" in
which the film is stationary.
The "internal-drum" camera comprises a drum 18.4 cm. in
external diameter turned from a duralumin forging and dished
internally to have a flat rim. The lens is arranged opposite the
hole in the end-plate and is accurately positioned by means of a
sliding carriage on which it is mounted. The bearings are of
high-speed ball-bearing type. They are designed to rotate during
short periods at rates up to a maximum of 24,000 revolutions per
minute. The maximum writing speed of the camera attainable
in use is limited by considerations of safety to about 175 metres
per second.
The rotating-mirror camera, housed in a box divided into two
compartments, is mounted on a stout wooden base and bolted
on the top of a rigid framework of angle-iron set in the concrete
floor of a laboratory. Adjoining the laboratory is a "gun room,"
where explosives can be fired, and in the dividing wall a square
window is cut opposite the lens of the camera. This window has
a sliding shutter which is closed whilst the camera is being loaded.
The mirror is a circular disc of stainless steel, 8.8 cm. in diameter
and 0.95 cm. thick, polished on both faces. It is designed to
rotate at speeds up to 8,400 revolutions per minute, this being
equivalent to a writing speed of 352 metres per second.
The rotating-mirror camera has been designed to give writing
speeds higher than those of the revolving-drum cameras.
Provision has been made for four standard writing speeds, namely,
88, 176, 264 and 352 metres per second, and a stroboscopic method
has been developed whereby any of these standard speeds can
be obtained at will.
In the photography of such a subject as an explosion of a gas
mixture confined within a narrow glass tube, a line image is the
natural result of the experimental conditions. When the subject
is a cartridge of an explosive, a screen must be provided, preferably
in one of the focal planes of the lens system, to limit the breadth
of the image.
In the determination of a rate of detonation, the cartridge of
explosive is suspended with its axis parallel to the slit in the
screen. An image of the cartridge is formed along the slit in the
screen, the width of the slit being a small fraction of the width
of the image.
To limit the exposure of the film during an experiment, a shutter
is arranged immediately behind the screen consisting of a brass
plate capable of sliding in vertical guides screwed to the back
of the screen. Until the shutter is raised, the rear compartment
containing the film remains light-tight and the curtain covering
the hole in the front of the camera may be raised without risk
of fogging the film. This enables the image focussed on the front
of the screen to be examined, and for this purpose a small observation
window covered by a sliding door is provided in one side of
the front compartment. It becomes possible, therefore, to record
a number of repeat explosions on one film, for the height and
alignment of the explosive suspended in the gun-room can be
verified by a visual examination of the image on the screen before
each experiment. To make an exposure, the shutter is pulled
to the top of its guides, where it hits a buffer, and is then allowed
to fall under its own weight. In the short interval of time during
which the slit in the screen is uncovered, the shot is fired by an
automatic timing device, and the point source of light traces a
datum line on the film.
One difficulty in applying the photographic method of measuring
the rate of detonation in cartridges of explosives on the Permitted
List has been the feeble luminosity of the flames produced by some
of them. One method of overcoming this difficulty is to recartridge
the explosive in a transparent wrapper of "cellophane."
This has given fairly satisfactory results, but is open to the
objection that the explosive may be altered somewhat, for example
in density, by re-cartridging. Mr. C. A. Naylor has suggested
a way out of the difficulty, based upon the observation that when
a file of cartridges is detonated the point of contact between two
cartridges is marked on the record by a brightly luminous spot
or line. A similar luminous effect is observed when a groove
2 mm. wide and 2 mm. deep is cut along the length of a cartridge.
An explosive which gave no photographic record whatever when
detonated in its original wrapper was prepared in this manner,
still wrapped as supplied by the manufacturers, and a determination
of the rate of detonation was made using a writing speed of
264 metres per second. The record is quite clear and sharp enough
for accurate measurements to be made. Repeat experiments
with other explosives giving satisfactory records without a groove
in the cartridge have shown that the presence of the groove makes
no difference in the rate of detonation.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Dautriche, — | | | |
| Gawthrop, — | | | |
| Jones, — | | | |
| Laffitte, — | | | |
| Mettegang, — | | | |
| Naylor, C. A. | | | |
| Payman, W. | | S.M.R.B. | |
| Perrott, — | | | |
| Shepherd, W. C. F. | | S.M.R.B. | |
| Woodhead, D. W. | | S.M.R.B. | |