|
23rd October 1937, Page: 121, Column: 2 Weathering Of Deposits Of DustBefore the Midland Institute of Mining Engineers Drs. F. V. Tideswell and R. V. Wheeler gave a paper on "The Dispersability of Mine Dusts," in which they said that the type of coal dust explosion against which it is necessary to guard is one where the means of ignition also provides the disturbance necessary to raise sufficient dust into the air to form a cloud capable of continuing the propagation of flame. The only likely means of ignition under present-day mining conditions is an explosion of firedamp of sufficient violence to provide both the concussion to raise the dust cloud and the flame to ignite the cloud. Sufficient dust is present on most mine roadways to form a sufficiently dense cloud. For example, on a roadway of 50 square feet cross-section a layer of coal dust (of average inflammability) no more than inch thick will provide a cloud of sufficient density to propagate flame. When a dust cloud is raised during an explosion, the most important agent in raising it is a blast of air (which may be either slowly or suddenly created, and may be continuous, vibratory, or swirling) passing over the surface of a deposit of dust. A close experimental study of the action of such blasts of air on deposits of dust has enabled three phases, consecutive but overlapping, to be distinguished: (1) The moving of the dust from rest; (2) the dissemination of the moving dust into the air; and (3) the immediate tendency of the cloud to settle according to the size and density of the dust particles. Referring to the weathering of deposits of dust the Authors said the effects of exposure to air on deposits of all the dusts tested is to make them more difficult to disperse. The cause of this is usually regarded as absorption of moisture from the air, but it is probably due to a number of factors which are operative to varying degrees according to the nature of the dusts and the conditions under which they are exposed. Even in the absence of moisture some deposits of dusts suffer a slow, but progressive, loss of dispersability which can be explained by the settling of the dust into a more compact mass. This effect has been observed particularly with limestone dusts. Loss of dispersability due to the action of moisture occurs after a few days' exposure of a deposit of dust to moist air and, for any particular dust, is proportional to the amount of water taken up by the deposit. As between one kind of dust and another, however, the loss of dispersability bears no relation to the amount of water absorbed or adsorbed. Thus, a shale dust that has absorbed 2 or 3 per cent. of water may have suffered no greater loss of dispersability than a limestone dust that has adsorbed 0.1 per cent. The action of water can be either physical or chemical, and can be described as follows: (i) Physical. — (a) Absorption into the particles of dust, which renders the dust heavier. This is observed with shale and coal, which absorb much water. (b) Adsorption on the surfaces of the particles, forming films which modify the nature of the forces (adhesive or electrostatic) acting between the particles. This effect probably accounts for the behaviour of limestone dusts. (ii) Chemical. — (a) Due to change in the nature of the dust, e.g., the hydration of anhydrite; (b) due to alternate solution and recrystallisation on the surfaces of the particles, observed with materials soluble in water, such as common salt and, to a lesser extent, with gypsum. Only effects II (a) and II (b) cause true caking of dust, yielding deposits which have appreciable structural rigidity. Caking, as thus defined, rarely occurs with dusts used for stone-dusting. Stating that their study of the dispersion of dusts has given several indications as to the way in which stone dust should be distributed on mine roadways to be most effective, the Authors conclude that since no stone dust is as readily dispersable as coal dust, the deposits should be accorded no less opportunity than the coal dust assumes of reaction to the force of an explosion. The area of surface bearing a layer of stone dust should therefore be as great as possible. There is evidently not much value in providing a thick layer of stone dust if only the surface dust is disturbed rapidly.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||