|
17th July 1937, Page: 11, Column: 2 Safety In Coal MinesDangerous Conditions or OccurrencesThese notes are based on the evidence and statements placed before the Royal Commission on Safety in Coal Mines. The Institute of Mine Surveyors was represented before the Royal Commission by Messrs. T. G. Bocking, M.Inst.C.E., and C. North, M.C., and some of the points in the statement of evidence submitted were as follow :— The Institute of Mine Surveyors has from its inception recognised the need for the proper technical education of mine surveyors in training, and the desirability of raising the standard of work of those at present engaged in statutory duties of mine surveying, having regard to the increased efficiency demanded by modern methods of mining, and the need for the prevention of waste and the encouragement of safety. The factors in mine surveying operations and in the preparation of statutory plans likely to contribute to dangerous conditions or occurrences are inter alia :— (1) Approach by a new mine or seam to older workings likely to contain, or known to contain, noxious gases or accumulations of water, in one or more of the following circumstances: (a) Where the position in plan, extent in plan, or horizon of the old workings is unreliable or unknown. (b) Where a plan of the old workings exists and is available, but is not capable of being attached to or correlated with a plan of the subsequent workings to any degree of reliability owing to one or more of the circumstances outlined in paragraph (2) following, or to lack of information on the plan relating to orientation and plotting meridians. (c) In the case of mine workings in steeply inclined measures, or where coal is won by adits or cross-measure drifts, a risk of unforeseen or premature contact is introduced by the lack of levels indicating the horizon of the workings, or if levels are shown, by their reference to an unreliable or incorrect datum. (2) Inaccurate or insufficient definition of the surface features or boundaries of the mineral take, due to one or more of the following factors: (a) Unreliable or unskilled survey of the main topographical features. (b) Errors in defining or fitting straight line boundaries over or upon irregular features such as streams, fences, parish boundaries, etc. (c) Errors in transposing a boundary from a small scale lease plan to the statutory working plan on a scale of 40 inches to the mile. (3) Intrusion into, or reduction of the desired width of coal barriers due to factors (2) (a), (b) and (c) or to causes outlined in paragraphs (4), (5) and (6) next following. (4) Inaccurate correlation of the direction of the underground roadways and workings in relation to the surface features, due to the selection of an unsuitable method having regard to the size and circumstances of the mine and/or take. (5) Inaccurate survey extensions and recording of the district workings due to the selection of an unsuitable method of secondary. surveying, or the inaccurate attachment thereof to the primary survey of the mine roadways. (6) Using and recording workings upon a plan for a new mine or seam, the surface features thereof being copied from a former plan, without checking and correcting for shrinkage and distortion and/or without checking the position of the shafts in relation to the boundaries of the take and the lines for underground orientation. Suggested Statutory Rule. As the evidence submitted by the Institute of Mine Surveyors inevitably consists of recommendations for improved technique the opinion is ventured that, until the Code of Practice published in 1935 by the Chartered Surveyors' Institution and the Institute of Mine Surveyors has been voluntarily adopted by a majority of mining surveyors, it is not desirable to make statutory rules on the matter, with the one exception recommended in the joint report, section 16, as follows — (i) On and after an appointed day every new plan of a mine, or of any seam of a mine, required to be prepared and kept under the provisions of Section 20 of the Coal Mines Act, 1911, shall be oriented with and correlated to the Ordnance Survey. (ii) Every such plan shall have laid down thereon a rectangular grid or graticule covering the area of the said mine in squares of not more than twenty chain sides, parallel in all respects to the grid of the Ordnance Survey of the- county or counties wherein the mine is situated and coincident with the sheet lines (or twenty chain sub-divisions thereof) of the Ordnance Survey maps of the area of the mine. (iii) There shall be clearly marked upon every such plan the Ordnance Survey co-ordinate values, at the point of intersection, of at least two lines of the graticule at right angles to each other, and where the area of the mine is appropriately located, the lines so marked shall be the division lines of the maps. There shall also be marked upon every such plan the values of the Ordnance Survey co-ordinates of the centres of all mines shafts, and/or station points at adit mouths, which form local points of origin or reference points of underground surveys. (iv) There shall also be laid down upon every such plan the surface reference base-line of the mine, or of a group of mines (or a line parallel thereto), and the value of the angle (calculated to ten seconds of arc) between such reference base-line and the local Ordnance Survey meridian shall be clearly marked thereon. (v) After the expiration of a definite period from the appointed day, every plan of a mine required to be prepared and kept under the provisions of Section 20 of the Act shall conform to and in all respects comply with the foregoing requirements. Advantage of Uniform Methods. The representatives of the Institute are, however, of the opinion that the adoption of uniform and specified methods of surveying, plan construction and plan maintenance, would obviate or diminish many of the dangerous features attached to old and existing mine plans, and they therefore summarise some of the relevant recommendations of the joint report as follows :— (a) All surface surveys and primary underground surveys shall be calculated and plotted by the system of rectangular co-ordinates, to the appropriate Ordnance meridian. (b) Orientation or correlation of the underground workings with the surface reference base-line or lines shall be carried out by one or more of the under-mentioned methods, to such a limit of error that the difference between two or more independent surveys does not exceed two minutes of arc (i.e., about one yard deflection per mile of extent). (1) By a single wire in each of two or more shafts; (2) By two or more wires in a single shaft; (3) By precise magnetic observations; (4) By direct connection through adits or inclined drifts. (c) Traverses or surveys of primary underground roads shall be extended from reliable reference points previously ascertained, and shall be systematically checked and examined by or under the supervision of the responsible surveyor in charge, at intervals of 500 yards of advance. (d) Subsidiary and face surveys shall be conducted from, and attached to, two or more survey stations previously established by the primary surveys or their extensions, and shall be carried out by or under the direct supervision of a person holding the prescribed qualifications as a mine surveyor. (e) All levels required to be shown on a mine plan shall be connected to the Ordnance Survey datum without arbitrary additions to or deductions therefrom, and surface levels shall be established at the shafts, adit mouths, etc., for use in referring and computing the mine bench marks or initial horizon. (f) Permanent bench marks of a suitable character shall be established at all insets to mine workings, and such bench marks shall be determined in horizon by actual shaft measurements from the surface datum. (g) Abandoned workings, or workings temporarily suspended, shall be check-surveyed immediately on such happening, to establish the position of all accessible points not previously surveyed. (h) Abandoned workings, or workings temporarily suspended, shall be check-levelled immediately on such happening at all accessible points not previously established. What Recommendation Means. It is desired to make it clear that the recommendation for a statutory requirement does not necessarily mean the adoption of the detail of Ordnance maps, but only of the co-ordinate system of the Ordnance Survey, co-ordinate plotting, and the gridding of maps in conformity therewith. The advantages of this are that there would be an immediate mathematical relation between all colliery plans, of particular value in regard to boundaries and barriers. For example, where the boundaries of colliery takes are not defined by surface features, they can be fixed by a sufficient number of co-ordinate points, and the position and width of each barrier can be agreed by the surveyors of the adjacent collieries concerned. As the gridding of the plans would be in definite and relatively small squares the scale of any part of any plan would always be known with a high degree of accuracy. At present in a large number of cases, shrinkage and distortion of existing plans has entirely destroyed their accuracy so far as scale and direction are concerned, and consequently the position of important parts of underground workings cannot be known with reasonable accuracy. The adoption of a co-ordinate system of plotting and gridding to a common system would greatly improve the accuracy of mine plans and consequently operate as a valuable safety measure. Many colliery plans are already correlated to the existing Ordnance Survey and there will be no difficulty in revising the correlation when details of the new triangulation are available. Before any decision is arrived at as to the date when correlation to the Ordnance Survey should be made compulsory, we think the Ordnance Survey should be consulted.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||