|
8th May 1937, Page: 345, Column: 1 Some Aspects Of Mine IlluminationBy Thomas Bryson, A.R.T.C., M.I.Min.E., M.I.M.S. From paper read at a joint meeting of the Past and Present Mining Students' Association (Wigan Mining and Technical College) and the Lancashire branch of the Institute of Mine Surveyors. The Author is president of the Institute Flame Lamps. When coal mining began in this country working was confined to the outcrops of seams. Naked lights were used, and probably explosions of firedamp became more numerous as the workings were extended under greater depths of cover. The first mention of an explosion is contained in the register of St. Mary's Church, Gateshead-on-Tyne, which, under date 14th October, 1621, reads "Richard Backas was burn'd in a pit." Even in early mining times some thought was given to the means by which explosions might be avoided, and the Transactions of the Royal Society of 1681 in commenting on the danger stated: "They keep quick their air and use no candles in their works, but a single wick, and these of 60 to 70 to the lb., which nevertheless gives as great a light there as others of 10 to 12 to the lb. in other places, and they always place them behind them, and never present them to the breast of their work." It was thus early realised that ventilation was necessary to dilute and render harmless the firedamp given off in the mine, and probably the effect of glare also was understood. Numerous references are made to explosions in records of the early eighteenth century, and in 1708 an explosion took place at Fatfield Colliery, Co. Durham, resulting in the death of 69 persons. In 1740 Spedding introduced his steel mill for the purpose of giving a safe light to colliers employed in fiery mines, but the light was poor and expensive, and it was too uncertain to be safe. Years passed and colliery explosions continued to occur with alarming frequency, and consequently a committee of persons unconnected with the mining industry persuaded Davy to study the question of how best to provide miners with a sufficient and safe light, notwithstanding that Dr. Clanny had in 1813 introduced his safety-lamp, which consisted of an airtight chamber, having a window in one side, into which the air required for combustion was pumped by a boy using hand bellows. A water seal was provided at the top and bottom of the lamp to extinguish any explosion that might occur within the lamp. Beside the original Clanny lamp two other lamps of great importance to miners are to be seen in the Science Museum. They are the first Davy lamps to be used underground, and each consists of an oil vessel surmounted by a cylinder of gauze 15 inches diameter by 5 inches high and having 6,400 apertures to the square inch. Later lamps were provided with iron wire gauzes having 784 apertures to the square inch, and the tin-can Davy lamp was placed in a tin can, having a window in it, for the protection of the lamp against high-speed explosive air-currents. George Stephenson was also at this time engaged in experimenting with the view of producing a safety-lamp, and in 1815 he, like Davy, bestowed a boon on the miners of that time by producing the Stephenson lamp. This early lamp had two important features of the modern flame safety-lamp; it had a glass cylinder surrounding the flame and a bottom air feed, but Stephenson delayed the development of the flame safety-lamp by a quarter-of-a-century by afterwards enclosing the glass cylinder in an outer cylinder of wire gauze. He made the modified lamp a safer one than the original, but robbed it almost completely of its lighting power. As Davy lamps were unsafe in air-currents having a velocity of 6 feet per second or more, Upton and Roberts sought in 1827 to improve the type, by surrounding the lower part of the gauze cylinder with a glass cylinder and the upper part with a metal cylinder, the bottom feed taking place through square holes cut in the ring above the oil reservoir and passing through a ring of gauze. It was not until about 1839 that the next departure in safety-lamp construction was made. Owing to the low illuminating power of the Davy lamp, Dr. Clanny in that year replaced the lower part of the gauze by glass, above which the air feed entered. The lamp was subsequently fitted with a bonnet round the upper gauze to make it safer in currents having a velocity of 8 feet per second or more. The illuminating power of the lamp was about one-third of a candle as compared with one-fifth in the case of the Davy, but due to conflicting currents in the lamp it was liable to smoke the glass and interfere with the light. Shortly after Clanny's innovation Mueseler (in 1840) designed a lamp of the Clanny type with the addition of a wrought-iron chimney, supported by a gauze diaphragm on the glass cylinder and reaching down to within one inch of the base of the flame. This was the first lamp to have controlled ventilation, it gave almost twice the illumination given by the Clanny lamp, and was safe in air-currents of really high velocity. The Eloin Principle. In 1844 the Boty lamp was invented. Its distinguishing feature was the bottom feed through holes in the ring below the glass, as in the Stephenson lamp. In 1846 the Eloin lamp was produced and it differed from the Boty in that the bottom feed passed through a gauze ring between the oil vessel and the glass cylinder, and there we find it to-day in most of our modern safety-lamps. The Gray lamp was first introduced in 1868 and it had the cage, containing the glass cylinder and gauzes, built of hollow tubes, down through which the air feed could be drawn from near the roof. By the addition of a shutter below the top of the lamp the upper inlet could be closed, and the lower could be opened by raising ferrules at the bottom of the air tubes. This was essentially a fireman's lamp; it had a conical glass in order to refract the light upwards towards the roof. The modern form of this lamp was the Ashworth-Hepplewhite-Gray lamp, and the principle was employed in the construction of the Stokes' alcohol tester and the Clowes' hydrogen lamp. In 1882, Marsaut, a French engineer, brought out his safety-lamp in which there were two gauzes, the inner one being intended to replace the metal chimney of the Mueseler lamp, which had given trouble due to the liability of extinction on being moved from the vertical. The lighting power of the lamp suffered in consequence, until, in 1889, Howat introduced the deflector ring above the base of the gauze. As lamps were then always bonneted the inlet air entered through annular slots in the upper brass ring and followed no definite path until, upon the introduction of the deflector ring, it was turned downwards on to the flame. Higher Candle-Powers. For many years the Marsaut was the typical lamp used in British mines, and lampmakers vied with each other in producing the best possible lamps of the type, but still the candle-power of such lamps had not reached unity. With a revival of interest in the Eloin principle of introducing part of the air feed through a gauze ring under the glass cylinder there was obtained a decided improvement in the illuminating power of safety-lamps. The Wolf lamp, which was patented towards the end of last century, embodied the Eloin feed and gave, probably for the first time, an illumination equal to one candle. Improvements were made in the methods of locking lamps, making wick adjustments, and in relighting lamps, but the present century was well on its way before the next notable achievement in lamp design was made. Following on the heels of the original Hailwood-Marsaut lamp came the Hailwood combustion tube lamp with its candle-power of about one and a half, and now there are available several high candle-power lamps of very good design. Fitted with reflectors the Protector, Hailwood, Naylor, and other lamps of the most recent construction provide the miner with enormously improved illumination, amounting to about four candle-power. The factors which have led to the improvement of safety-lamps are the Eloin feed, the Mueseler chimney, the combustion tube, proper blend of fuels, the use of 20-mesh gauze, and the more liberal dimensions of the lamps, especially the gauzes. [To be continued.]
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||