2nd January 1937, Page: 197, Column: 2
The Methane Detector
Tests in American Mine
Before the Pennsylvania Anthracite Section of the American
Institute of Mining Engineers Mr. Arthur Glance, the Safety
Inspector of the Salem Hill Colliery, in a paper on "The Methane
Detector as an Aid to Mine Safety," said there were various
instruments on the market which record in direct percentages the
amount of methane present in the atmosphere. He instanced
the Burrell methane detector, the Wolf, the Martienssen, the Mine
Safety Appliance detector, and the Union Carbide Company
methane detector, which last he has used extensively in making
mine inspections. This methane detector utilises the effect of
combustion of methane upon the surface of a heated filament,
connected in an electrical circuit. The combustion of methane,
on the filament, increases its temperature and consequently its
electrical resistance, which causes a deflection of an indicating
needle in the circuit. The deflection is dependent upon the
concentration of methane in the atmosphere and is indicated in
percentage on the methane detector dial.
The paper by Mr. Glance appears in the Institute's MINING AND
METALLURGY, and the following notes on tests he made may be
of interest :—
"The following practical test took place in the Salem Hill mine.
The assistant foreman and myself met in a chamber and we
decided to check each other in testing for gas. The vein was
11 feet thick and worked on double timber, pitch 300. After a
slight delay to build a scaffold so that we could reach the roof,
the assistant foreman made his test with a lamp and reported it
clear. With the detector I merely took the miner's dressing bar,
inserted the dressing edge under the clip on the side of the detector,
and hoisted the detector to the roof. The meter registered 1½ per
cent, of gas. This surprised the assistant foreman, because 1½ per
cent, of gas can be capped on a flame lamp. To check himself,
a higher scaffold was built so that he could see the flame on the
same level as his eye and check his test more closely. This was
done and a cap appeared on the lamp.
One of the gangways was next examined. It was dusty and
one could barely see. I asked the miner if the place was clear
and he replied that it was, and that t-he only burning in his lamp
that he could detect was caused by the high dust content in the
air. Upon looking at my instrument, which is unaffected by
dust, I found 2 per cent. of methane. To prove my findings we
immediately reduced the dusty atmosphere by sprinkling the
section thoroughly with water, which is piped to the face of all
our gangways for fire protection. Within a short time the dust
was settled and I had him check again with his flame lamp. A
noticeable cap could then be seen on the lamp, which again proved
the difficulty of determining the methane content with a flame
lamp in an atmosphere at all dusty.
"The following test was made in a flat seam, 6 feet thick. The
place driven was 24 feet wide and 200 feet long. Testing here with
the average flame safety-lamp could only be done within 3 inches
of the roof, owing to the fact that the hanging hook of the flame
lamp displaces 1 inch of height and the bonnet 2 inches more.
If a 3-inch layer of methane were along the roof, the average flame
lamp would not detect it and the place would be passed as clear.
A place of this type could contain a large quantity of methane
which, if ignited, would have disastrous results. With the methane
detector, practically perfect detection can be made, for the detector
can be held in a horizontal position against the roof and any gas
present thus detected.
"As a final example, let us go to the main return. Often
returns when tested for gas by the flame lamp are reported as
clear, but upon testing with the methane detector the results are
surprising. The colliery return delivers 106,000 cubic feet of air
per minute. Testing with the flame lamp showed the return clear,
but testing with the methane detector showed a daily average of
0.8 per cent. methane. A day's delivery of gas from this return
showed 184,320 cubic feet of pure methane being released."
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Glance, Arthur | | Safety Inspector | |