5th December 1936, Page: 163, Column: 2
Air-Borne Coal Dust
In the discussion arising out of the reading of the paper on
Air-borne Coal Dust: Abatement of the Nuisance in Intensive
Conveyor Mining," by Mr. A. L. Davies before the South Wales
Institute of Engineers, Mr. R. C. Wain said that the production
of fine dust at the coal face was of primary importance and this
was influenced to a marked degree by coal-cutting and shot-firing.
The amount of dust made by mechanical cutting might
be reduced by an alteration in the position of the cut and a slower
chain speed. Over-cutting would often give less dust and effect
economies in labour and power charges. There was no doubt that
the use of explosives produced much dust, and Cardox or Hydrox
which were less shattering in their action, would do much to
improve conditions in this respect. An extensive experience in
actual working practice drove one to the conclusion that the best
way to deal with dust underground was to collect it dry. Water
had a very damaging effect on conveyor plant, and often caused
serious movement of the strata which was most undesirable at
loading points where it was necessary to maintain large roads
and regular gradients. That most of the dust dispersion took
place from the tram was well understood. This was due to the
dust in suspension being carried up by the air displaced by the
coal being loaded into the tram. It seemed that in South Wales
where large trains were in use the problem of collecting dust was
not a difficult one. The most convenient and effective place
to pick up the dust was at the top of the empty end of the tram.
Every use should be made of the ventilating current to direct the
dust-laden air to the collecting point and simple deflectors attached
to the conveyor loading chutes should be provided for this purpose.
Two means of clarifying air charged with dry dust bad been tried
out underground-cyclones and bag filters. Experiments carried
out with cyclones confirmed the opinion that even a comparatively
small concentration of dust in the air could cause considerable
discomfort to men working in the immediate vicinity. The bag
filter was positive in its action, inexpensive, and easy to transport
and erect in the pit. Very compact units could be obtained which
gave ample filter action area and a low resistance. Not less than
1 foot of filter medium should be allowed for every 5 cubic feet of
air per minute to be cleaned, and the resistance of the whole
apparatus would then not exceed 2½ inches of water-gauge where
the air ducts were of reasonable size. A slide was fitted to the
base of the filter from which the dust was discharged into bags
and sent out of the pit. In most cases they were working on
conveyor loading points which were planned without any thought
being given to the collecting of dust, and he was of the opinion
that in future when loading points were designed to provide
such facilities, many of the existing difficulties would be absent.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Davies, A. L. | | Mining Engineer | |
| Wain, R. C. | | Mining Engineer | |