|
16th October 1936, Page: 743, Column: 2 Notes from the Coal FieldsYorkshire[Local Correspondence.] Mr. J. Kenyon Parker (Sheffield district coroner) resumed the inquest at Rotherham on Tuesday, on the three men killed in the cage accident in the Brook House shaft at Beighton Colliery on Sunday. September 27. The victims were W. G. Brindley, overman, C. E. Linton, deputy, and T. E. Leadbeater, ripper. W. R. Turtle, chief mechanical engineer to the Sheffield Coal Co., said he was responsible for the mechanical equipment of the Beighton and Brook House pits, including the winding and guide ropes. The cage involved in the accident had been in use about five years, and had been quite satisfactory. After the accident he examined from the surface the winding rope and guide ropes, and found the latter twisted round the former, nearly up to the surface level. Later he went to the bottom of the shaft, and so far as he could see up the shaft the guide ropes were little different from normal. They were closed in very little. In answer to Mr. H. J. Humphrys (H.M. divisional inspector of mines) witness said an examination of the shaft revealed that the cage had caused a bumping. There was a small piece of wood out of the bunting, as though a corner of the cage had caught it. On one corner of the cage there were some small pieces. The normal clearance between the bunting and the flat side of the cage was 4 ft. 6 in. If the cage had only spun round and had not swung in the shaft, there would not have been an accident. Witness told Mr. Herbert Smith (Yorkshire Mineworkers' Association) that he did not think it would have made much difference if the guide ropes had been at the corners of the cage. In reply to Mr. F. Scorah, representing the Sheffield Coal Co., Turtle agreed that in his experience it had always been the policy of the directors to have "safety first" irrespective of expense. R. Bennett, agent for the Sheffield Coal Co. since April 14 last, said that the Brookhouse shaft had, in his experience, been rarely used, and in cases of emergency, excepting for the purpose of repairs. A scheme for equipping the shaft with two cages, each fitted with four guides, was sanctioned by the directors just over two months ago. Mr. C. W. Scott (junior inspector of mines) said that the Brookhouse shaft was 420 yd. deep and 18 ft. in diameter. It was a downcast shaft, only used for ventilation and as a second exit. Except for repairs, this shaft was rarely used for winding persons. On September 27 it was being used to wind a small shift of repairers and officials as the rope in the main shaft was being re-capped. Although a maximum of ten men was allowed in the cage, there were 11 in it at the time of the accident. When the cage got about halfway up the shaft it began to spin round and swing. At 50 yd. below the surface the top of the cage at the gate end struck a bunting, which was normally 4½ ft. clear of the cage. This caused the cage to tip up. The weight of the men thrown against this gate caused the gate to burst outwards, and the three men nearest the gate were thrown into the shaft, with the gate, and fell 370 yd. to the bottom. The jury returned a verdict of "Accidental death." and said they agreed with Mr. Scott that the excessive spin on the new rope and insufficient resistance of the two guides were contributories to the accident.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||