|
29th August 1936, Page: 55, Column: 2 Skip WindingThe eight Divisional Reports of the Mines Inspectors are now available and may be obtained at the price of 1s. through H.M. Stationery Office. Every mining man should at least secure possession of the Report relating to his own inspection area. The documents convey information and advice of a nature that justifies the devotion of time to their study. In due course some of the points will be gathered together in these pages, thus presenting not merely an isolated instance but the general experience of the coalfields, so that the lesson may have the merit of wider authority. Skip winding is a feature of interest to many readers, who may be interested to note that in his Report on the Yorkshire Division Mr. H. J. Humphrys states that last year a skip winding plant was put into Operation in No. 3 shaft of Grimethorpe Colliery. This shaft is 21 feet in diameter and in it the Beamshaw Seam is wound from a depth of 506 yards. The present output is 600 tons a day, but it is expected to reach 2,000 tons. The electrically driven plant is designed to wind 3,300 tons a day from the Parkgate Seam at 850 yards. The full tubs, after being weighed, are emptied underground in a two-tub rotary tippler into a chute which consists of a concrete lined drift driven to the shaft side at a gradient of 1 in 1. This chute, which acts as a storage bunker and holds about 45 tons of coal, is divided near the shaft side into two separate steel structure chutes, each of which feeds one skip. Two skips of the bottom emptying type, running on rope guides and each having a capacity of eight tons of coal, are installed in the shaft and there are two rotary valves in the shaft bottom for loading them. Each valve consists of a large circular drum against the inside of which the periphery of the chute abuts when the valve is in the "off" position, so that coal cannot puss into the shaft. A nose is fitted to the valve and, when the valve is in the loading position, this projects into the top of the skip and forms a continuation of the chute so that coal is free to flow into the skip. The operation of the valve is controlled by the skip which, on descending, lands on a beam which it thrusts down into the shaft bottom. This beam is connected by pulling rods to the valve so that its descent causes the valve to rotate into the loading position. When the skip is full the flow of coal in the chute chokes itself; the skip, in ascending, raises the nose of the valve causing it to rotate back to the "off" position again and the coal in the nose itself falls back on to that in the chute. No spillage occurs either from the skip or the valve. An electrically-operated quadrant valve is provided in each chute to cut off the flow of coal when men are to ride in the skip. At the surface, rollers on the door of the skip and one on the catch, which holds the door closed, enter special guide paths in the headgear. A deviation in the catch guides causes the catch to be released so that the door is under the control of its rollers in their guides. As the skip ascends higher, the distance between it and the guide paths increases so that the door is opened until it forms an inclined chute down which the coal slides into a hopper and thence on to conveyers which take it to the screens. The operation of the plant is automatic apart from the winding engines and signalling. A compartment in which 14 men may ride is built underneath the skip. Ormerod safety detaching hooks are provided.
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||