9th May 1936, Page: 345, Column: 2
Resistances Of Steel Props
In a paper on "The Resistances Developed by Steel Supports,"
before the South Wales Institute of Engineers, Mr. L. J. Barraclough,
M.Sc., recorded the results of observations on the resistances
developed in steel props and cogs used as roof supports on long
conveyor faces in the Upper Four-feet seam at two adjacent
collieries in Glamorgan. The depth in each case was 750 yards;
the coal varied from 6 feet to 7 feet 6 inches in thickness ; the
roof was of strong clift (shale) up to 3 feet thick, overlaid by a
sandy bed 2 feet thick and succeeded by strong clifts. The
floor was a medium hard underlay, which could be cut or notched
by a pick with but little difficulty, in the statement summarising
the conclusions the Author said it appeared from tests with 4-inch
by 2½-inch by 2-inch section props, with a square-cut base and
turned over top, at the first colliery that the resistances developed,
even after considerable convergence, were so low and variable
that the temporary supports could have but little effect in controlling
the roof; great improvements in roof control were
effected subsequently by improving the quality of the packing.
Under similar conditions at a neighbouring colliery the use of
steel props with 6-inch circular ends was also associated with low
and variable resistances. Some improvement in the convergence/resistance
ratios was effected by substituting steel lids for those
of French timber. With props set on 12-inch diameter bases a
more nearly linear relationship existed between convergence
and resistance until roof penetration occurred, the maximum
resistance depending on the type of lid used. The use of such
large bases, however, was not practicable. Steel cogs have a
gradually-increasing resistance to a maximum of 168 tons, the
convergence/resistance graph indicating a direct relationship.
The convergence/advance ratio with such supports was less than
on a similar face without them, but was greater than where
sectional packing was carefully done, in the given conditions
it appears that efficient packing, and not the use of steel props,
is the main factor controlling the roof.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Barraclough, L. J. | | | |