|
28th March 1936, Page: 292, Column: 1 Problems Of Coal UtilisationResearch and Changes in Market RequirementsBefore the Institution of Civil Engineers on the 17th March Dr. F. S. Sinnatt, C.B., M.B.E., read a paper on "Some Major Problems in the Utilisation of Coal" in which he emphasised among the factors of importance in the economical utilisation of coal (a) The selection of the right coal for the purpose in view; (b) Its preparation by cleaning and sizing into convenient grades; (c) The design of the plant. In connection with these factors he drew attention to (1) The Fuel Research Coal Survey, which is obtaining information of the properties of the seams in all the main coalfields; (2) The recent developments in the preparation of coal for the market and in processes for the cleaning of fine coal, and particularly the work being done on the breaking and sizing of coal; (3) The developments in the burning of coal in pulverised form; (4) The technique for the transformation of tar and coal into motor-spirit by hydrogenation. Diversity of Seams. Dr. Sinnatt explained that although a plant may be highly efficient with coal of suitable characteristics, use of the wrong fuel may cause great losses. One of the difficulties experienced by producers and consumers arises from the diversity of the seams in the British coalfields. The coals on the whole are extremely pure, but they not only vary in properties from seam to seam, but frequently from place to place in the same seam. Wide variations in properties may occur. For example, in a distance of ten miles the whole character of the Nine Feet seam of South Wales changes in passing from east to west. The volatile content changes from 34 per cent. to just over 15 per cent., the ratio of carbon to hydrogen rises from 16 to 1 to over 21 to 1 and the yield of tar by low-temperature carbonisation falls from 12½ per cent. to 2½ per cent. When such rapid changes in composition occur, Dr. Sinnatt said, co-ordinated information is essential to the collieries if they are to market coal of uniform quality. One of the aims of the coal survey was to prepare maps of the various coalfields showing where coal of, say, the same volatile content may be obtained. One such map had been prepared for the Busty seam of Durham. The coal in this seam possesses outstanding coking properties and, together with others in the same coalfield, is the source of the excellent metallurgical coke produced in north-west Durham. As the seam is traced in a south-easterly direction its volatile matter content increases until on the other boundary it is used for gas-making. The map may be used as an accurate guide to the way in which the coal varies from point to point in the coalfield, and therefore to determine the industrial use for which it is best suited in each district. What Survey Reveals. As a third example, Dr. Sinnatt referred to the Parkgate seam of South Yorkshire, which probably extends into the Nottinghamshire and Derbyshire coalfield as the Deep Hard seam. As the seam is traced to the south it shows rather striking changes in the contents of fixed carbon and of moisture, and the calorific value and caking power markedly decrease. The survey of these two seams covers a distance of 50 miles from north to south and embraces some 2,000 million tons of coal. These seams, although they change only slowly in chemical properties, vary considerably in thickness (2 to 7 feet) from place to place with layers of bright coal above and below it. The percentage of dull coal over the field varies appreciably. "Although the dull and bright coals have similar chemical analyses, they are quite distinct in properties. The bright coal is highly caking and is used for the manufacture of coal gas and metallurgical coke, while the dull coal possesses only slight caking properties, and is used as a locomotive coal and for general steam-raising. To meet these different markets the dull and bright coal are sorted out by hand picking, but, generally speaking, it is not possible to separate them when the coal is small, although a process has been described in which the coal is fractured and the larger dull coal is screened off the smaller bright coal. The smaller sizes separated from run-of-mine coal are a mixture of bright and dull, so that their properties are governed by the proportion of the two types present, it follows that coal of a similar size from different collieries may not have the same characteristics, although it is derived from the same seam. The difference in properties will not affect the efficiency of many plants, but may be important when the coal is used for carbonising or, sometimes, for raising steam." The situation is further complicated by the fact that collieries, as a rule, mine two or more seams at the same time. The natural corollary of a survey of coal in the seam is therefore an examination of the commercial grades produced at the pithead, which is being carried out in Lancashire and in South Yorkshire. The total production of coal in the South Yorkshire field in 1934 was 28,760,000 tons, of which 20,450,000 tons were smailer than 3 inches in size and therefore suitable for washing ; 16,020,000 tons, or about 80 per cent. of the coal under 3 inches in size, were mechanically cleaned. New Dry-cleaning Plant. Enormous advances have been made in coal cleaning plant. Whilst there are still four times as many wet-washeries as dry-cleaning installations in operation, the latter are increasing rapidly in numbers. Recent improvements in washing plant have been mainly directed towards making the process fully automatic, but dry-cleaning plant, relatively an innovation, has been very much improved. A new type of air-jig dry-cleaner is being developed at the Fuel Research Station, in which the coal is fed. into the hopper above the plant, and passes down through the feed pipe into the back of the cell, which is 3 feet long and 1 foot wide near the bottom. Above the cell and extending its whole length is an air duct, said Dr. Sinnatt, to which suction and pressure are alternately supplied by bellows mounted immediately above. On the suction stroke, air is drawn through the coal causing it to loosen and rise slightly; on the pressure stroke, the air is forced downwards again and the bed is compressed on to the grid which forms the bottom of the cell. The repetition of the cycle causes coal and dirt to stratify, coal rising to the top and dirt falling to the bottom. The bed breaks on the suction stroke to leave a space into which fresh coal flows. Dirt is withdrawn through an off-take at the bottom, and clean coal flows from the top over a weir. A glass window is fitted to each end of the cell, so that its operation can be followed ; the correct jigging action is obtained by adjustment of the speed and stroke of the bellows. The advantage of this plant is that is handles ½-inch to 0 coal without any pre-screening or de-dusting. The power the machine uses is low and the problem of dust does not arise. The plant, Dr. Sinnatt added, must still be considered to be in the experimental stage, but it already seems probable that it will fill a gap in the range of dry-cleaning equipment. Under modern conditions of intensive machine mining, there is an increased production of fine material, which usually contains a higher proportion of impurities than the larger coal. If these can be separated, however, the fine coal can frequently be reduced to a lower ash content than the large coal. This is one of the most difficult problems facing the coal industry. The fine coal in question is obtained during screening and dedusting, or as slurry from wet washeries. Attempts are being made to use it, when dry, as pulverised fuel and, if inexpensive methods of removing grit from the flue gases can be introduced, some of the objections to this practice will be eliminated. Graded Coals. In certain coalfields the demand for large coals, both for industrial and household purposes, is decreasing steadily. This has made the installation of coal-breaking machinery necessary and has turned attention to the conservation of graded sizes present in the run-of-mine coal. Graded coals are becoming increasingly valuable, and it is therefore necessary to study the breakage characteristics of coal and the coal-breakers installed, to determine the most economical manner in which the critical sizes can be produced. The consideration of degradation in size during handling and transport is equally important as well as the effect of each of the treatments which coal has to undergo upon the sizes in relation to their commercial value. How many commercial undertakings are aware of the effect of handling and transport upon the potential output of graded sizes from the "face" where the coal is first won, and what proportion of those graded sizes ultimately reaches the consumer? Work on this subject at the Fuel Research Station had shown that in one case run-of-mine coal containing 13 per cent. of a particular size contained only 4 per cent. of that size when it reached the consumer. In another case coal breakers were producing 20 to 35 per cent. of a particular size, whereas, when the coal bad been transported to the central screening plant and had passed through it, only one-half of the quantity of that size was available for sale. The breakage of coal, Dr. Sinnatt said, is in fact becoming of paramount importance and raises problems which must arouse the interest of all engineers. The question of the size in which coal was sold was also under examination in several of the coalfields. It seems to be generally recognised that a reduction in their number is desirable, as may well be believed when in one coalfield over one hundred different grade sizes of coal are produced by the collieries. Over a large part of the Continent eight sizes have been standardised, and this range is considered to be sufficient. Pulverised Fuel. Referring to pulverised fuel Dr. Sinnatt said the chief factor governing the extension of its use is the price of small coal. The cheapness of small coal and slack compared with larger coal had made it worth while for a number of large consumers to invest in grinding mills and other equipment for dealing with pulverised fuel, but the capital expenditure necessary has deterred small undertakings from turning over to pulverised fuel. Pioneers among coal distributors have sought to meet this situation by establishing central pulverising plant and undertaking its delivery to the consumer in tank-wagons. It had proved difficult, however, to burn pulverised fuel with a short flame, and a large combustion chamber has been considered necessary for complete combustion. Dr. Sinnatt described the new burners developed at the Fuel Research Station designed to deal with this problem. One of these burners, the grid burner, he said had been used successfully to raise coal in Lancashire and Babcock and Wilcox boilers over long periods with little supervision. If necessary, supplies of air can be preheated; this was advantageous when burning Welsh coal with only 15 per cent. volatile matter, but was not found necessary when using coals with 20 per cent. Satisfactory operation has been obtained with fuels containing from 20 per cent. to 35 per cent. volatile matter, and efficiencies of 74 per cent. have been maintained in a Lancashire boiler without a pre-heater or economiser. These trials were carried out when evaporating steam at the rated load of 5,000 lb. per hour, but just recently it has been found possible at the Fuel Research Station to raise the load to 10,000 lb. of steam per hour, without the efficiency failing below 68 per cent. Indeed, as this difference can be largely attributed to a higher flue gas temperature. 835°F., instead of the 590°F. at rated load, it should be possible for a commercial installation, fitted with a larger economiser than is normal, to work at the same efficiency with 100 per cent. overload as at the rated load. Promising results when working under such conditions have already been reported from outside firms.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||