29th February 1936, Page: 257, Column: 1
Blasting In Coal Mines
A paper on "Recent Developments in Blasting in Coal Mines"
by Mr. J. Hancock, M.Sc., F.G.S., was read at the February
meeting of the Manchester Geological and Mining Society, developments
in shot-firing apparatus, low density explosives, sheathed
explosives and simultaneous shot-firing all being dealt with. The
view was expressed that low freezing explosives, now used throughout
Great Britain, have eliminated the occurrence of accidents
previously occasioned in the handling of frozen explosives. With
capped fuses the capping operation is done at the factory and
their use reduces the incidence of miss-fires, always a possible
source of hazard with loss of time and money.
With reference to developments in shot-firing apparatus the
conclusion was reached that a possible cause of some of the gas
ignitions which had occurred and for which no satisfactory
explanation had been forthcoming, was the occurrence of a spark
at the mouth of a shothole, as a result of the momentary crossing
of the bared ends of the electric detonator leads or shot-firing
cable conductors, just as the shothole was breaking down or
stemming was being ejected, and while current was still being
generated by the exploder. This resulted in modifications in
exploder design and the safety of the exploder has been steadily
increased, "Approved Exploders" being stated to he incapable
of giving a spark which can ignite firedamp under any conditions.
Another development has been the introduction of the battery
type exploder, giving adequate power and yet offering full safeguard
against gas ignition. It should be noted, however, the
Author explained, that with this type of exploder it is essential
to make adequate arrangements for the removal of the battery
in good time to maintain efficient functioning. So far, the battery
type exploder has not made a very wide appeal in the coalfields.
Before the low density explosives were submitted to the Buxton
Test, preliminary field trials were carried out in open light mines
in November, 1930. Experience has confirmed the good impression
formed in their early application. While the low density
explosives have the low bulk strength desirable for lump coal
production, they have at the same time good weight strength.
Thus their introduction in a colliery has usually shown a reduction
in the weight of explosive used per ton of output, which offsets
their slightly higher price, necessitated by the more careful supervision
and increased work in their manufacture and packing,
and the larger cartridge wrappers, packets and cases required in
packing.
In general, these explosives will find useful application in undercut
seams showing good cleavage, and bedding planes with a
well-pronounced roof parting, where lump coal production is a
consideration. As permitted explosives, they can only be used
for bringing down coal. In ripping, large charges per shothole
are commonly used, and with low density explosives this would
involve long columns of explosive, leaving little room for stemming
with the consequent risk of blown-out shots; hence the restriction
of these explosives to coal work.
From the make-up of the sheathed cartridge, the Author said
with reference to sheathed explosives in practical use, it will be
readily appreciated that in use the sodium bicarbonate sheath
should remain intact both during the making of the primer
cartridge and the loading of the cartridges in the shothole. The
practice of rubbing the cartridge between the fingers before
insertion in the shothole should be avoided in the case of sheathed
explosives. Careless loading operations whereby the outer wrapper
of the sheathed cartridge might be torn should be avoided, as
in this event the sodium bicarbonate might be spilled, thus
obviating the proper functioning. There is a further possibility,
where the explosive charge consists of two or more cartridges,
that the spilled sheathing material and part of the torn wrapper
might be carried forward by the next cartridge, thus forming a
cushion between the two cartridges and tending to prevent
propagation and to leave an undetonated cartridge. It is obvious,
therefore, that when loading sheathed cartridges heavy pressure
should not be used to squeeze them up in order to obtain
concentration of the charge at the back of the shothole. The
cartridge should be pushed gently home, making sure that they touch.
Owing to the extra thickness of paper at the end of the sheathed
cartridge, it is preferable to use a pointed peg of soft metal —
aluminium or brass — when making the hole in the primer cartridge
to take the detonator.
Under certain working conditions such as in strong rippings
or hard coal, concentration of the explosive, charge at the back
of the borehole is a decided advantage. When this is the case,
if the same overall diameter of cartridge is used with the sheath
explosive as with the ordinary permitted, then the concentration
of power will be affected, owing to the elongated form of the
sheathed cartridge weight for weight, and it will therefore be
desirable to increase the diameter when changing over to sheathed
explosives, that is, to maintain the diameter of the actual explosive
core. Since their introduction in February, 1933, the use of
sheathed explosives has steadily increased, but it is hoped, that
their application will have much more extensive use. Already
a good lead has been set by many of the leading collieries throughout
the coalfields, where their use has become firmly established.
Apart from the accepted factor of increased safety, among the
claims for sheathed explosives which have been made in the
field are: (1) Reduced fumes from shot-firing-probably due to
better supervision of the shot-firing practice ; (2) Slight increase
in lump coal-partly accounted for, no doubt, by partial absorption
of the shock wave by the cushion of tile sheath.
In recent years, as the development of blasting explosives has
continued, the Author said, there has been considerable investigation
into other methods of breaking down coal. Cardox was
introduced into this country at the beginning of 1930. Briefly,
the Cardox cartridge consists of a steel shell containing CO2
which is gasified at high pressure by a heating device. The
expanding gases burst a steel disc and on venting break down
the strata surrounding the shothole.
The successful application of Cardox showed the practicability
of using a steel container provided with a venting system for
blasting purposes. A new development of Cardox was called the
Hydrox cartridge, and tile filling composition Hydrox Powder.
The shotholes should be drilled to give a finishing diameter of 2".
The cartridge is inserted in the shothole and stemmed where
possible. Also according to the Explosives in Coal Mines (Hydrox)
Order, 1935, a sprag must be set in the front of the shothole.
The cartridge is then fired with the ordinary shot-firing cable and
exploder.
So far, Hydrox trials in coal blasting have been carried out in
some twenty or so collieries in various coalfields. Hydrox in its
present form has been developed essentially for breaking out
coal. No doubt, however, the present Hydrox blasting cartridge
will find some limited application in ripping. Research work
continues, and it is possible that later on a strengthened Hydrox
steel tube cartridge may be developed, enabling the hardest
coal measures end stronger rippings with increased burdens to
be dealt with successfully.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Hancock, J. | | | |