12th October 1935, Page: 104, Column: 2
Pressure Losses In Mine Airways
At the meeting of the Midland Institute of Mining Engineers
held on 3rd October a paper on "The Use of the Inclined Gauge
for the Determination of Pressure Losses in Mine Airways" was
submitted by Messrs. Robert Clive and John G. Bromilow, B.Sc.
(Hons.), describing a simple method of carrying out a ventilation
survey without the use of delicate instruments which at the same
time provides an accurate picture of the varying resistance along
the whole length of the airways traversed. The specific object
of the survey was to accurately ascertain how far it was possible
to economically improve the ventilation system and permanently
reduce the cost of maintenance.
The apparatus for recording pressure differences consists of
an inclined water-gauge fitted to a set of dial legs and 100 yards
of ¾-inch diameter flexible hose which is laid in the airway, one
end being attached to one leg of the inclined gauge and the other
end open to the air. Paraffin is used in the gauge in place of
water to give a more clearly defined meniscus. The difference in
pressure between points in the airway at each end of the 100
yards pressure pipe is read on the inclined gauge. After the
reading has been taken the pipe is moved forward and the pressure
loss ascertained over the next length of airway ; the gauge is then
moved forward and the process is repeated for the whole length
of the airway to be surveyed. The readings given by the inclined
paraffin gauge require to be divided by 13.04 to give the pressure
loss in inches of w.g. An adjustment is necessary for difference
in velocity pressure to give the total pressure loss over each
length.
It was claimed that with ordinary precautions a high standard
of accuracy could be achieved by this method, which is more than
sufficient for all practical purposes. General particulars were
given of three separate surveys where it was possible in each case
to check the sum of the pressure drops on each length of the
survey with a gauge reading between main separation doors, the
margin of difference in the three cases being 1.2 per cent., 1.1 per
cent, and 0.6 per cent. respectively. The advantages of the
inclined gauge were summarised, viz., simplicity, can be carried
out by the colliery staff, no delicate instruments required, the
pressure loss is given direct for each length of airway, no correction
required for variation in level or variation in barometric pressure.
The loss of pressure can be ascertained with certainty for any
short length of known restriction and the effect of the removal
of the restriction on the efficiency of the ventilation accurately
estimated. The resistance in the fan drift, pit bottom mouthings,
restricted air-crossings; sharp bends, etc., can be ascertained with
a high degree of accuracy. The resistance of standard lengths
of different sizes of airways with various types of supports can
be easily compared. Increased resistance to be expected in
consequence of extension of districts can be estimated accurately.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Bromilow, John G. | | | |
| Clive, Robert | | | |