Logo Museum
Museum
Friends of Durham Mining Museum
Events Calendar
e-Books and Books for sale
Photograph Gallery
Document Archive
Main Document Archive
Newspaper Articles
Articles by date
Articles by colliery
Personal name index
Local Record Extracts
D.M.A. Document Archive
Transactions of I.M.E.
Miners' Welfare
N.C.B. Archive
The Colliery Engineer
The Colliery Guardian
Mine & Quarry Engineering
Mining Journal
The Science and Art of Mining
Coal Magazine
Coal News
Coke and Gas
Master Name Index
What's new in the site
Mining
Mining History
Colliery Index
Colliery Maps
Company Overviews
Who's Who
Mineral Information
Managers Certificates
Educational Material
Bibliography
Statistics
Workers/Employee Lists
Notes for Family Historians
War Service information
Disasters
Disaster Reports
Names of those killed
Disasters in the 1700s
Disasters in the 1800s
Disasters in the 1900s
Memorials
Awards for Gallantry
On this day ...

Links to other sites of interest
Industrial Heritage Days Out
Former www.pitwork.net web site

Index to site

Contact and address details

Share Page with Social Media

Share on Facebook

Share with Reddit

Share on Delicious


 Newspaper Articles Index Newspaper Articles 

22nd June 1935, Page: 394, Column: 1

Deterioration Of Haulage Ropes

As part of the research programme of the Wire Ropes Research Committee of the Safety in Mines Research Board, an investigation has been made into the causes of failure of twenty-three haulage ropes (used for hauling men) broken in service at collieries. Full particulars of the ropes and their conditions of service were collected and samples from the broken ropes thoroughly examined and tested. S.M.R.B. Paper No. 92 (H.M. Stationery Office, is. net.) summarises the results of such an examination of the causes of failure of a number of ropes and indicates the relative importance of the various factors which caused the deterioration of the ropes.

In their introduction Professor S. M. Dixon and Dr. M. A. Rogan say the deterioration of haulage ropes in service may be attributed to three factors, war, corrosion and fatigue. It is difficult, however, to classify the various failures under these headings because as a rule they are the result of the combined operation of several forms of deterioration. Haulage ropes are particularly susceptible to external wear through rubbing against the floor, sides or roof of the roadway, through the use of several layers of rope on the drum and through the action of clips or lashing chains on endless rope haulages. If the roadway is wet, corrosion of the worn surfaces will accelerate the deterioration on account of the abrasive action of the corrosion products on the various surfaces which rub together as the rope is bent over drum and pulleys. Again, if a rope is undergoing internal corrosion this will be accelerated by wear between the wires as the rope is bent. Wear and corrosion acting together tend to produce rapid deterioration, resulting in serious reduction in the cross-sectional area of the wires. When the section of the wires is reduced sufficiently to cause the stress on them to exceed the fatigue limit deterioration by fatigue will begin.

Of the ropes examined twenty-one were in use on main rope haulage systems where the haulage roads were inclined up to a maximum of 60°. The other two were the main ropes on main-and-tail haulage systems. Deterioration was found in all the ropes. The predominant type of deterioration associated with nine of the failures was wear, with ten corrosion, and four were classed as capel failures.

The Authors say the selection of a rope for use on a given haulage depends on the system of haulage in use and on the working conditions, such as gradient, size of engine, drum or driving pulley, and the amount of moisture on the road. The various points they direct attention to divide into three groups: (a) the strength of the rope to be used; (b) the type of rope (c) the construction of the rope.

The strength of the rope to be used is obtained by multiplying the calculated maximum tension by a factor of safety; this gives the breaking strength of the rope required, the maximum tension being obtained from a consideration of the heaviest load which may be hauled by the rope, due allowance being made for the inclination, friction and the weight of the rope itself. It is impossible to lay down a standard factor of safety for haulage ropes. The Authors' experience indicates that on main rope haulages no rope should be allowed to remain in service after the static factor of safety has fallen below 6. When the rope is new the factor of safety should, in general, be considerably more. A somewhat lower factor of safety may be used on slow speed endless rope haulages.

As to the type of rope external wear is one of the most serious causes of deterioration of haulage ropes, and it is desirable to choose a type which is as resistant to wear as possible. The view is expressed that where external wear is the most serious form of deterioration a flattened strand rope should give better results than a round strand rope.

The strength of a flattened strand rope of a given diameter is usually greater than that of a round strand rope because a flattened strand rope, owing to its formation, contains a greater cross-sectional area of steel. Hence for a given strength, the flattened strand rope will be smaller, and will contain somewhat smaller wires than a round strand rope. Under certain circumstances the reduction in diameter of the wires may be a grave drawback, and the flattened strand rope may give less satisfactory service. Splicing is more difficult.

Under the heading (c) the type of steel to be used in the wires, the make-up of the strands, the core, and the lubrication of the rope during manufacture are considered. The properties of the materials and the methods of manufacture should be in accordance with the relevant British Standards Specifications.

Installation of Haulage Ropes.

Extracts from the section dealing with the installation of haulage ropes are reproduced as follows :—

It is desirable that the haulage engine should be smooth running and capable of starting up gradually so as to avoid jerking the rope. The brakes should be smooth in action for the same reason. The diameter of the drum and pulleys should be as large as possible, and should be proportioned to the size of the wires in the rope. Where a number of pulleys or rollers are used in a group to lead the rope round a curve so that the angle which the rope bends over each pulley is small, the diameter of the pulleys may be reduced.

The haulage road or incline should be provided with rollers wherever the rope would otherwise be likely to rub on the floor, roof, or sides. In no case should the rope be allowed to rub against hard rock, or rails or other fixed metal objects. Care must be taken that pulleys and rollers are so mounted that no gaps are left between the roller and casing in which the rope may become wedged. All pulleys and rollers should run freely and must be provided with reliable means of lubrication. Rollers in which grooves have been cut by the rope should be replaced at once.

The grooves of pulleys should be smoothly finished to a radius slightly in excess of the radius of the rope. The pulley grooves should be carefully inspected at intervals, and, before a new rope is fitted, should be trued up if reduced below the proper size.

Every effort should be made to keep the haulage rope dry to reduce the risk of damage to the rope by corrosion. If water is unavoidably present it should be led to a drain on one side of the road, and not allowed to run where the rope may dip into it.

A wire rope must be handled in such a way that it is not allowed to untwist, and great care must be taken to avoid kinking.

When the rope is put to work it is likely to he lively, and special care should be taken that kinking does not occur when the rope is allowed to go slack.

Maintenance of Haulage Ropes.

Space is devoted in Paper No. 92 to the maintenance of haulage ropes, and some of the points to which attention is directed by the Authors may be briefly noted, as below:

Main ropes used on inclines from the surface can be treated as follows. The rope should be wound very slowly on to the drum, the surface being cleaned as it enters the engine house ; cleaning should be done with wire brushes without using any solvent such as petrol or paraffin. No solvent (petrol or paraffin) should be used on the rope because experience has shown that the solvent readily penetrates into the middle of the rope and rapidly dissolves out any remaining lubricant. The rope should be allowed to remain on the drum long enough to allow it to dry as much as possible.

When the rope has been cleaned and dried the lubricant should be applied by hand with a fairly stiff brush. The successful lubrication of a haulage rope calls for a good deal of skill and patience, but unless it is properly done the time and materials are wasted. It is better to do a portion of the rope well each week than to waste a lot of grease by applying it to the whole of the rope without cleaning and drying.

It is not possible to lay down any fixed periods for the lubrication of haulage ropes because the periods will vary with the working conditions. A rope which makes a large number of journeys on a wet incline will need lubrication every week, whereas a rope which makes only a few journeys on a dry road may be kept in good condition by less frequent treatment. Excellent results have been obtained on endless rope haulages where the rope was lubricated continuously.

The inspection or examination of a man-haulage rope is just as important as that of a winding rope, since the consequences of a breakage may be equally serious. In many of the failures described the report of the rope examiner on the condition before fracture was mere optimistic than warranted by the facts. Only 3 out of the 23 ropes had been reported to be otherwise than in good condition, that is to say 20 ropes broke although they had been examined and reported to be in good condition. Since many of these ropes broke in consequence of severe external deterioration their conditions should have been apparent for some time before the breakage. This suggests that the methods of examination practised at the collieries were unsatisfactory. There are good grounds for urging that a rope should be given a special examination, at definite intervals, in addition to the regular examination. The most convenient time for making the special examination is when the rope has been cleaned preparatory to lubrication.

Haulage ropes are specially liable to deterioration close to the capel owing to the reflection of the kinetic shocks at that point. The rope is also liable to deterioration due to bending at the mouth of the capel. Because of this tendency to deterioration haulage ropes are recapped at intervals. The Law requires that the rope should be recapped at intervals not exceeding six months, but in many cases a shorter interval is desirable. When the rope is recapped a length should he cut off, sufficient to remove the portion liable to deterioration near the capel. The removal of this piece of rope "moves on" the rope at other places liable to deterioration, as for example, on the pulley at the top of the incline or at the drum, when the haulage is being started. At many collieries it is customary to cut off a length of rope equal to one circumference of the drum, every three months, and it is suggested that not less than six feet should he cut off in all cases.

Assuming that the examination of the rope has been properly carried out, the colliery manager is faced with the problem of deciding when the rope must be removed from service. The diameter of the rope is the simplest index to its condition, and, if account be taken of the type of deterioration to which the rope is subjected, useful conclusions may be drawn from changes in diameter.

It is suggested that no rope should be allowed to remain in service after the outer wires at the most worn section have lost 40 per cent. of their diameter. Whether a rope should he allowed to reach this fairly advanced stage of deterioration will depend on the initial margin of safety and on the working conditions. If these are such as to cause fatigue the rope may be in a dangerous state long before the outer wires are worn down 40 per cent. Consequently a rope showing heavy external wear should only be left in service as long as the outer wires remain free from fatigue, i.e., as long as there are no broken or cracked outer wires.

The rope failures are dealt with in detail in the Paper, grouped according to whether the failure of the rope, as judged by the tested samples and the results of mechanical tests, was found to be due predominantly to wear, corrosion, or capel failure.


Names mentioned in this article

 

 Name  Age  Occupation  Notes 
Dixon, S. M., Prof.      
Rogan, M. A., Dr.      


 

mail
Mail:
Webmaster
Back
Back
Home
Home
Open Government Licence   Contains public sector information licensed under the Open Government Licence v3.0.

Copyright © 1999-2024 by The Durham Mining Museum and its contributors
Registered Charity No: 1110608
Page last updated: 28 Nov 2022

Privacy Policy
 
Terms & Conditions
 
Search
Search
Print
Print