2nd March 1935, Page: 263, Column: 2
Cooling Electrical Machines
In a paper at a meeting of the Institution of Electrical
Engineers on the 14th February Mr. Ralph Poole dealt with
"The Application of Propeller Fans to the Cooling of Electrical
Machines." He said experience shows that propeller fans can
be designed to suit almost all machines ; the deciding feature is
ultimately cost. For high pressures it is essential that the radial
tip clearance shall be small in the case of a propeller fan, but this
requirement increases the cost considerably. The final decision
therefore rests between cost and efficiency and is a matter for the
customer rather than the manufacturer. It has been found that
in certain cases the propeller fan is quieter than the centrifugal
fan, but in general the former requires more careful design to
prevent noise. The propeller fan is most suitable for cooling
transformers, and it is possible that in the near future the question
of transformer cooling will be dealt with as a separate subject,
i.e., since the type of fan, high-pressure or low-pressure, may
determine the arrangement of cooling tubes. While forced
ventilation may become economical, this is a matter for further
investigation by transformer designers.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Poole, Ralph | | Electrical Engineer | |