19th January 1935, Page: 219, Column: 1
Coal Measure Rocks
In the SHEFFIELD UNIVERSITY MINING MAGAZINE the paper by
Dr. D. W. Phillips, of the Safety in Mines Research Board, on Coal
Measure Rocks, discusses their nomenclature, constitution, strength
and elastic properties. The varying strengths and bending
capacities of the different strata lying above and below coal seams
have a bearing on the problem of roof control, and in relation to
the practical significance of the results of the investigations referred
to in the paper the Author adds the following notes
The Strength of the Rocks. — Reference has been made to the
limitations of laboratory tests on the strength of the rocks in view
of the constrained circumstances of the rocks in situ. However,
the results of the tests afford a relative scale of strengths, and it
is recognised that the actual strengths of the rocks in situ are
greater.
The rule used by mining engineers to compute the force acting
on the rock at depth is 1 pound per square inch per foot of depth.
At a depth of 4,000 feet, probably the maximum at which coal is
being worked in this country at the present day, this rule gives a
pressure of 4,000 lb. per square inch.
The compressive strengths of coal measure rocks as determined
in a testing machine and loaded at right angles to the lamination
are greater than 4,000 lb. per square inch. The rocks here considered
are not the weak clayey rocks which are often met with
in the vicinity of coal seams, but the normal shales and sandstones,
and these rocks are sufficiently strong to withstand the weight
of the superincumbent strata at mining depths, previous to mining
operations.
Now, why do these rocks break in consequence of mining ? The
explanation is that the forces are redistributed and are concentrated
along certain planes where the induced stresses attain a magnitude
sufficiently high to fracture rocks.
The Importance of Resilience. — The fact that rocks are elastic,
or in other words are resilient, thus permitting of an elastic
rebound" at the moment they are relieved of load, is a great
source of danger during mining operations. The energy developed
during the straining of the rocks by transverse forces ("bending
strains"), is potential while the rocks are in a state of strain.
During the elastic rebound" of the rocks into the unrestrained
position, this energy becomes kinetic and is transmitted suddenly
to the surrounding rocks. The rocks subjected to this impact
may, in consequence, be shattered. The liberated energy also
manifests itself in the form of vibrations transmitted through the
rocks, and in the form of sound, both of which always accompany
a rock burst.
The resilience varies directly as the span of the strained strata
and inversely as their elastic moduli, hence the strength and elastic
properties of the rocks are of importance in the study of rock
bursts in mines.
The Bending Capacities of Rocks. — In describing the behaviour
of mine roofs reference is always made to the bending of the rocks.
A study of the relative bending capacities of the different rocks
in a vertical sequence will give an idea of the loading conditions
likely to be met with during mining operations.
Considering two strata lying immediately above a coal seam, if
the lower stratum has a greater bending capacity than the higher
it will bend away from the latter and thus to some extent relieve
itself of weight. In this case, however, the unsupported span of
the higher stratum will result in an increase of pressure at the point
where the bending of the lower stratum begins. If the condition
is reversed, i.e., the lower stratum has a less bending capacity, it
will be loaded along its whole length by the higher stratum. The
problem becomes more complicated when a series of beds is considered.
It is very necessary to remember then, that it is not only the
visible roof that has to be considered and that trouble may arise
from the beds above, which cannot be seen. In one case there may
be a large weight of material over the immediate roof of a coal
seam, while in another case the roof is to some extent protected
from weight by a stronger band of rock.
The reason for apparently contradictory statements regarding
root behaviour in mines may be due to attempts to compare
conditions having different vertical sequences.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Phillips, D. W., Dr. | | Safety in Mines Research Board | |