|
8th December 1934, Page: 164, Column: 1 May (1934) ExaminationsReport of Central ExaminersThe Board for Mining Examinations has issued the report of the Central Examiners on the examinations in May last for certificates of competency as managers and under-managers. In this and succeeding issues the — comments of the Examiners on the candidates' answers will be reproduced in italics following the setting of the questions, the plans and sketches being omitted. The official Question Papers are obtainable in pamphlet form (2s. net) through H.M. Stationery Office. Winning and Working (1st Class). (1) A level seam, 5 ft. thick, is undercut to a depth of 4 ft. 6 in. each day on a longwall face. The roof is fairly hard shale and 60 per cent. thereof is supported by packs. Make a cross-section of the face, showing in detail how you would expect to find the lines of fracture in the roof; and under what conditions you would expect the roof (a) partially to lock itself, (b) to be liable to continual falls. What difference would you anticipate in the roof if the same seam was got by hand? (50) Although it is evident the great majority of the candidates have some knowledge of the reports of research on this subject, the answers were rather disappointing. This applies more particularly to that part of the question where it is asked where the fractures could be expected to occur under certain conditions of working. (2) Name the subdivisions of the Carboniferous system and give the position it occupies in relation to the preceding and subsequent systems. (40) On the whole the answers were very satisfactory. (3) Five hundred tons a shift have to be brought up an incline 1,000 yards long and dipping 1 in 4. A balanced double-drum direct haulage, capable of hauling 20 tubs on each rope. is installed. Explain, with sketches, how you would lay the rails at the top of the incline, and explain in detail the system you would use at the top and bottom of the incline so as to get the ropes moving again expeditiously. (40) This question was not well answered; in the great majority of instances the lay-out was impracticable. It was often suggested at the top of the incline to have only two lines of rails suitably graded, one for full tubs and one for empty tubs; this would not work with two ropes. The candidates did not take into account the friction of the rope owing to the length of the incline, as no special provision was made at the bottom, not even to the extent of having graded roads. (4) A shaft is to be sunk on the coast. There are 30 ft. of drift clay, then 100 ft. of soft water-bearing strata containing sea water, overlying the rock head. Explain generally how you would get through to the rock head. (40) This question was not well answered, In the majority of cases only brief outlines were given of the system suggested. Many candidates recommended the freezing process, which would not be desirable under the conditions laid down. (5) Describe a pneumatic gob-stowing machine. Under what conditions would you apply it ? Also, what kind of dirt would you feed into it ? (40) Very few candidates are familiar with this type of machine. Those who had some knowledge were hazy regarding its applications A number of candidates realised that large lumps of dirt were not suitable, but very few mentioned that the small dry dirt, if used by the blower, creates an excessive amount of dust; a few suggested washery refuse, which is most suitable. (6) "Shot-firing has been made safer and more efficient by scientific research." Discuss this statement ; also give your views on low density explosives. (40) This question was well answered. The precautions to be observed whilst shot-firing were well known, also the reasons why these precautions are desirable. The views on low density explosives differed rather widely. (7) Describe fully how you would put down a borehole to a depth of 35 yards from an underground roadway whose normal dimensions are 12 ft. wide by 6 ft. high. Give details of the various tools required. (40) The majority of the candidates answered this question satisfactorily, and the sketches were commendable. The arrangements which would be made in the roadway prior to boring were of a practical character. Ventilation (1st Class). (1) On the plan which accompanies this paper, show how you would arrange for the distribution of the air-currents, using the signs and colours as given in the Regulations. Sheets to be shown thus S. (50) Nearly half the candidates gave satisfactory arrangements; most of the others were open to the objection of hauling much of the coal in the return air, unnecessarily. A few ignored the requirement of a second intake airway, and some who showed the two intakes used both for haulage of coal, which is not allowed. Opening out workings inside a fault is a regular operation in the great majority of collieries, and it is surprising to find that about 80 per cent. entirely failed to ventilate the working places in the lower district beyond the fault. (2) Describe a combustion tube safety-lamp of the type largely used three years ago ; and then give an account of improvements introduced into this type recently with the object of giving more light, showing how this has been achieved. (30) A small number of candidates gave a good answer. Others gave a portion only of the improvements. Others evidently are not aware of recent developments, and described the original combustion tube lamp of years ago, as a recent introduction. (3) Describe, with sketches, a main ventilating fan of the centrifugal type. State what other types of fan have been recently introduced for ventilation purposes, and enumerate their advantages or disadvantages as compared with the first-named type. (30) Few good answers to the first part of the question. Most candidates dealt with the second part satisfactorily. (4) A quantity of 150,000 cubic feet of air is passing through a mine with a 3-inch water-gauge. Calculate (a) the water-gauge necessary to produce 200,000 cubic feet under the same conditions. (b) What ventilation horse-power (or air horse-power) is generated in each case ? (c) If the mechanical efficiency of the plant is 66 per cent., what energy would have to be supplied for each quantity? (30) About half the answers were correct throughout and got full marks. About 10 per cent, of the candidates did not understand the correct relationship of the water-gauge readings with the rate of flow of air. The arithmetic of many answers was deplorable; often absurd answers were produced, which a moment's thought would have shown to be wrong. (5) In deep and hot mines, to what causes do you attribute the high temperature ; what effects are observed on the workmen's health; what precautions and arrangements are desirable in order to reduce these troubles ? Suppose the workings in a seam of coal are fairly fiat, and lie at a depth of 2,400 feet, make an estimate of the temperature of the air at, say, two miles inbye, showing how you arrive at your figure. (30) Nearly all gave a good account of this phenomenon, especially of the effect on workmen, and of the precautions desirable. In working out an estimate of the temperature of the air, most made this too high ; some of them abandoned the result of their calculations, and gave satisfactory answers from their own experience. The principal error in the calculations was that of treating the self-compression of the air in the downcast shaft as additive to the temperature rise derived from the strata and other sources, which results in temperatures that are too high. (6) Give a detailed account of the plant and appliances you would install for ventilating a pair of sinking pits 20 feet diameter, expected to reach a depth of 600 yards and passing through fiery coal measures. Show how to ensure a supply of fresh air at the bottom of the pits during sinking. (30) Most answers were good, but a few provided insufficient plant. Almost everyone rightly favoured a blowing fan. The latter part of the question was well answered. (7) Sketch a regulator capable of giving an area of 3 square feet for the passage of the current and calculate the quantity you would expect to pass with water-gauges of 1 inch and 2 inches respectively applied to this area. Assume the air weighs 0.08 lb. per cubic foot. (30) Most candidates made the regulator adjustable, which is in accord with practice. A few made the area 3 feet square instead of 3 square feet. A good many wasted their time in calculating an exact square opening, whereas a rectangular one is usual. Most of the air calculations were excellent. Explosions, Etc. (1st Class). (1) Specify the possible causes of colliery explosions. Describe fully the precautions that should be enforced to guard against the risk of explosions. (30) The possible causes were fully stated in the majority of the answers, but in dealing with the second part of the question as to the precautions, the effects of an explosion were too frequently referred to. (2) Set out the conditions which may give rise to spontaneous heating — (a) in coal pillars; (b) in the goaves of longwall workings. What can be done to reduce the liability to heating in each case? (25) Generally the answers were satisfactory and showed understanding in the practical side of the subject. (3) Give fully but concisely an account of the present state of knowledge with regard to the dangers of coal dust and the measures which should be taken to ensure safety. (25) The answers indicated that the candidates were fully alive to the great danger of coal dust, and to the necessity for adequate stone-dusting, but the importance of systematically cleaning up the coal dust before stone-dusting was often overlooked. (4) At a depth of 300 yards from the surface there is an isolated area of old workings, full of water, which require to be tapped and drained, the inclination of the seam being 1 in 4. The working levels in the same seam are 80 yards to the dip of the old workings. Sketch and describe how you would approach the old workings to tap and drain off the water. (25) The majority of the candidates suggested driving a narrow road from a point immediately to the dip of waterlogged workings with the usual boreholes; they made no provision for a safety dam, or pipes to convey the water. Very few suggested approaching the old workings on the line of strike, or level course, such procedure where possible being much safer than on the full rise of 1 in 4. (5) What are the principal dangers to be guarded against by an underground exploring party immediately after en explosion and before the arrival of the rescue brigade? How should they proceed, and what should they take with them? What evidence should ultimately be looked for to locate the point of origin ? (25) Candidates quite properly referred to the great danger of carbon monoxide poisoning, but they often overlooked the danger of disturbed timber, fires, and the liability to a second explosion. (6) A gob-fire occurs unexpectedly in a district of a mine in which large quantities of firedamp are given off. No preparations have been made, and there is risk of explosion. What would you do? (25) The question clearly refers to a gob-fire in a fiery mine creating a dangerous situation, and many of the answers were unsatisfactory. Some candidates neglected to withdraw the men, others suggested stopping the fan. In such cases the men must always be withdrawn, and the ventilation maintained to prevent firedamp accumulating in the region of the fire whilst stoppings are quickly built of any available material to seal off the area.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||