10th November 1934, Page: 133, Column: 2
Oil To Coal Conversions
That "Fuel oil for steam raising and central heating is a very
expensive luxury" was the main theme of an address on "Conversions
from Oil to Coal Firing," given at the Manchester College
of Technology on Tuesday, 30th October, by Mr. H. L. Pirie,
M.I.Mech.E., Chief Engineer of the Coal Utilisation Council.
Mr. Pine gave three examples — of a hospital, a laundry, and a
dairy — where coal and oil had been carefully tested in the same
boiler plant on a strictly comparable basis. The results, expressed
in terms of the cost of evaporating 1,000 lb. of water, showed a
saving of over 61 per cent in the case of the hospital and the
laundry, and of over 36 per cent. in that of the dairy. In the
latter the coal was of a higher quality, smokeless, and hand fired.
The cost was also affected by the distance from the railway
station and the cost of transport.
Mr. Pirie included amongst his illustrations of recent conversions
a luxury hotel, a hospital, a laundry, a dairy and a prepared food
factory, because such undertakings were the most exacting in
their requirements regarding the emission of smoke and general
cleanliness. Referring particularly to smoke prevention, he said
"The idea of underfeed firing had been in use in England for
many years. It ensured that the fire would always burn with
a glowing surface, the raw coal being fed from underneath. This
resulted in the maximum radiant heat being transmitted to the
boiler heating surface and also prevented the formation of smoke
because the volatile matter, as it was distilled from the 'green'
coal, was burned in passing through the incandescent zone above."
Sometimes, said the speaker, solid fuel was not the most convenient
form in which to use coal. In the metallurgical industries,
for example, gas or fluid fuels were for certain processes essential.
Producer gas was increasingly used, and this was made from the
complete gasification of raw coal. One sometimes came across
buildings which had been definitely laid out for oil firing and it
might be difficult if not impossible to install coal burning equipment.
In such cases, "fluid" home produced fuels such as gas
or creosote might be used.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Pirie, H. L. | | Chief Engineer | |