10th November 1934, Page: 131, Column: 2
The Correlation Of Coal Seams
At a meeting on the 27th October of the North of England
Institute of Mining and Mechanical Engineers a paper was read by
Dr. Arthur Raistrick, Ph.D., M.Sc., F.G.S., on "The Correlation
of Coal Seams by Microspore Content (Part 1 The Seams of
Northumberland)." Pointing out that the collection and particularly
the storing of complete seam pillars of a variety of coals
present a difficult problem when many scores of coals are being
examined, the author said a direct comparison was made between
the results obtained from the examination of the microspore
content of a seam, in preparations made from a pillar, and from a
channel sample from each of four different seams. After repeated
experiments it seems clear that for general correlation purposes, a
channel sample of a seam is sufficiently reliable. In collecting a
channel sample, a channel is cut down the cleaned face of the seam,
about 2 in. wide and of uniform depth, using a sharpened hammer
point, to give about 3 to 6 lb. weight of fine coal chippings, according
to the thickness of the seam. These chippings are pounded till
the whole mass has passed through a 10-mesh sieve. This bulk
sample is quartered down until about 4 oz. of average coal are
obtained. This is pounded carefully and frequently shaken on
a 50 or 60-mesh sieve until all has just passed through. This coal
is used for the microspore separations. Trial of various grades
of grinding from 30 to 90-mesh indicate that 50 to 60 is the best
size for the reactions involved, and is large enough in comparison
with the actual microspore sizes to prevent excessive breakage of
the spores. With coal ground to 70-mesh, as much as 50 per cent.
of all the spore-content may be broken, but with 50 to 60-mesh,
the broken material is very small, So long as the methods of
grinding, sampling, and treatment are kept strictly the same for
all samples, the separations will have the same value for comparison,
and the small proportion of broken material can be
neglected. For future reference it is useful to keep a sample of
the average coal, and for this purpose 2-oz. square tins with fairly
tight lids have been found very suitable. As the first part of the
treatment consists of oxidation of the coal, there is no need to
attempt airtight containers for the samples.
If the microspore-content of coals is to be used for correlation
purposes, then two conditions must be fulfilled: (a) the microspore-content
of the coal of different seams must be sufficiently different
in its proportions for the seams to be distinguished from one another,
and to be recognisable by definite characteristics of the microspore
assemblage; and (b) the characteristics of each seam must be
recognisably constant over a wide area, comparable to the area
of the coalfield.
It is suggested that for general correlation work it is first necessary
in any coalfield to establish the vertical succession of seam
diagrams in several places where the correlations are known,
building up a complete succession in collieries as close as possible.
This vertical column will give a standard of reference with which
any group of seams in that part of the field may be compared,
while a few of the wider worked coals will serve to link it with
similar columns in other areas. Valuable additions to the knowledge
and ease of recognition of individual seams will probably
be obtained from the detailed examination of pillar samples of a
single seam, and recognition of characteristic bands by spore-content.
The examination of one or more seams over a very wide
area would provide a valuable datum-line of use in all correlation
problems.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Raistrick, Arthur, Dr. | | | |