|
21st July 1934, Page: 4, Column: 1 Simultaneous Shot-FiringReports on firedamp explosions due to shot-firing having shown that it is often the second or subsequent shot of a series which causes ignition, the Shot-firing Sub-Committee of the Explosions in Mines Research Committee has made a study of the possibility of avoiding successive shots by simultaneous firing. The result of the study is S.M.R.B. Paper No. 85 (H.M. Stationery Office, 6d. net). The chief objection to simultaneous shot-firing being an undetected misfire with its attendant dangers, apart from general considerations particular attention was directed to this aspect of the problem. In Great Britain, simultaneous shot-firing is prohibited in coal mines to which Part II. of the Explosives in Coal Mines Order applies, except in stone drifts and sinking pits. This prohibition was inserted in 1912, by the Home Office, and appears to have been based on the assumption that firing two or more shots together is more likely to cause an ignition of gas than when the same shots are fired singly. The present regulations are contained in the Explosives in Coal Mines Order, 1934. In some general considerations the Report points out that when two or more shots are required in a ripping a comparison between single and simultaneous shot-firing is as follows :— Single Shot-firing. — The operations of single shot-firing may be carried out in three ways :— (1) The shot-holes can be drilled, charged and fired separately: This method takes considerable time, and the conditions under which the shot-firer has to carry out his statutory examinations are usually less favourable with each succeeding shot. For example, apart from the risk due to falls, places previously accessible may be rendered inaccessible by the debris brought down. (2) The shot-holes can be drilled., and then each charged and fired separately: A possible danger with this method is that a shot may cause undetected damage to one of the uncharged shot-holes. (3) The shot-holes can all be drilled and charged, and then each fired separately: A disadvantage of this method is that it is not always possible to gauge accurately to what extent the firing of one shot will affect the work apportioned to an adjacent shot. Simultaneous Shot-firing. — The firing of shots simultaneously eliminates all the difficulties outlined under single shot-firing. Only one examination for gas, and that under the most favourable conditions, has to be made before firing. The whole of the operations can be carried out in less time than by any method of single firing, and the risk of igniting gas liberated by a previous shot does not arise. On the other hand, certain prima facie objections to simultaneous shot-firing can be advanced. The first of these, the fear that its adoption might increase the risk of igniting firedamp, should have been largely removed as the result of recent research, it having been shown that under test conditions there is no danger in firing together two or more shots, each containing the maximum permitted charge, than in firing them singly. Objections other than that of increased risk of misfires, with which this report deals in particular, are the possibility of greater risk of falls and the greater complication of the firing circuit. The possibility that the firing of a number of shots simultaneously may increase risk due to fails, owing to there being a greater shock to the surrounding strata than when the shots are fired singly, has not been borne out in practice. A series firing circuit is but little more complicated than a single shot circuit and no difficulty has been experienced in this respect. Practical Observations. Following a description of the experimental work at collieries and quarry (indicated by letters) the following, practical observations are made on simultaneous shot-firing :— Ease of Making Connections. — Good connections are easily made by twisting together the ends of the detonator wires and then knotting them. These connections cannot be pulled apart — the wire will break first — and the resistance is no greater than that of a continuous length of wire. It is desirable to use detonators with leads sufficiently long to reach from one shot to the next and thus to avoid joining up with short pieces of wire. Possibility of Testing Circuits. — Tests for continuity are easily made by means of a small galvanometer and cell. Separate instruments no larger than an ordinary match box are available, or the galvanometer can be incorporated in the exploder. Nature of Misfires. — All the misfires met with in this work were due to the current passing too low to fire the whole of the series. Manner of Detecting and Dealing with Mis-fires. — In the quarry misfires were sometimes difficult to detect and a careful search was required. Where the leads were not damaged, the shots were afterwards fired singly. In one instance, where the leads had bean damaged by the other shots, the misfire was recovered by drilling a second hole and firing a relieving shot. In another instance a shot did so little work that it was thought to have misfired. The detection of misfires in the drifts was facilitated by means of arrows chalked on the sides and roof of the read, previous to firing. Alter each round of shots a careful search was made for possible misfires before work was resumed. Another method adopted was to stem the shot-holes to within about 6 inches of the mouth and to plug the ends of the holes with pieces of wood about 12 inches long. When a shot misfired the wood remained in position. Relative Amounts of Explosive Required. — In the quarry, a reduction of about 10 per cent. of explosive used was effected by simultaneous shot-firing, in one of the drifts, the reduction was estimated at 15 per cent. and in another 10 per cent. These reductions were due partly to the use of less explosive in each shot-hole and partly to a reduction in the number of shots fired. In the drift at Colliery A, no reduction was observed. Relative Times Taken for Firing Shots Singly and in Series. — In the quarry, where no tests for gas were made and where travelling to a place of safety was not difficult, very little time was saved. In the drifts, the firing of four shots in series occupied less time than the firing of two singly. Where six or more shots were fired together, the saving in time was from 30 minutes upwards, depending on the distance of the ventilation pipes from the face of the working. In the drift at Colliery C, rising 1 in 2, the saving of time in the firing of a round of four shots in series was approximately one hour. In this case simultaneous firing saved three journeys up a steep incline. Production of Smoke. —In the drifts the smoke appeared to be in proportion to the number of shots fired. Effect on the Roof. — So far as could be observed, simultaneous shot-firing had no more effect on the roof than the firing of the same number of shots singly, in the drifts, more material was thrown along the road. Summary. The advantages of simultaneous shot-firing may be set out as follows Increased safety; greater efficiency of blasting; economy of effort; and saving of time. The one disadvantage which has been suggested is the possibility of an undetected misfire. The results of this research show that :— 1. A series of low-tension detonators can be fired with certainty provided ample current is passed through it. 2. There is nothing to be gained by a closer grading of the electrical resistance of the bridge-wires of detonators than that at present adopted by the manufacturers (0.9 to 1.3 ohms). 3. It is preferable that detonators with bridges made from wire of different diameters should not be used in the same series. 4. A battery exploder is a reliable means of firing detonators in series. 5. Special attention should be paid to the condition of the shot-firing cables. The sub-committee's observations underground have been confined to ripping shots in naked-light mines, and to shots in drifts. They now consider it desirable that observations should be extended to safety-lamp mines and should include shots at the coal face. The Paper is signed by the members of the sub-committee as follows: J. A. S. Ritson (chairman), D. H. Currer Briggs, H. M. Hudspeth, W. D. Lloyd, Hugh F. Smithson, R. V. Wheeler.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||