|
12th May 1934, Page: 339, Column: 1 Possibilities for Extended UseThe Inspector in Charge of the North Western Division, Mr. W. J. Charlton, describing briefly the "Sylat" prop invented by Mr. Walter Sylvester, says this is a safety prop with the usual wedge to facilitate setting and with means provided for locking the head to the prop. To release the prop all that is necessary is to remove the security pin, insert the hook of the usual five-yards Sylvester chain in the link provided, and give a sharp flick to the chain; sometimes two or more flicks are required, according to the load upon the prop. This operation serves the double purpose of unlocking and withdrawing the head, the load upon the prop assisting. The prop falls in the direction of the drawer, who gives a sharp jerk to the chain if the falling roof threatens to bury the prop. This steel prop will sustain heavy loads, and has the merit of easy withdrawal, as well as easy recovery from wastes, without the operator having to return to the released prop and expose himself under unsupported roof. There are without doubt, in the view of Mr. Charlton, great possibilities for an extended use of steel props. At a colliery in North Wales there was great difficulty in maintaining a conveyor face in a seam six feet in thickness, due to the breakage of wooden props. S.F. type props 6 ins, by 5 ins. section were introduced early in 1931, and they have revolutionised the conditions. Falls of roof at the face, which were not only a danger but a hindrance to output, no longer take place. When wood props were used, every single one was broken and chocks had to be set to keep the roof from coming down on to the floor. Since the introduction of steel props it has been unnecessary to set chocks on the face. The one disadvantage of the steel props as compared with the discarded wood ones is the increased weight, and in this connection it is interesting to record that the colliers in all parts of the mine now clamour for steel props. Just before steel props were introduced at this colliery, whilst the height between the floor and the roof close to the face was six feet, at a distance of 16 feet from the face it was only 3 ft. 6 ins. Under the new conditions created by the use of steel props, the height at the same distance from the face is 5 ft. 4 ins.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||