|
25th November 1933, Page: 148, Column: 1 May (1933) ExaminationsReport of Central ExaminersThe Board for Mining Examinations having issued the report of the Central Examiners on the examinations in May last for certificates of competency as managers and under-managers, the notes and comments of the Examiners will be reproduced in this and succeeding issues, the comments being in italics following the setting of each question. The plans and sketches are omitted. The official Question Papers are obtainable in pamphlet form (2s. net) through H.M. Stationery Office. Winning and Working (1st Class). (1) Sketch a lay-out of the sidings and main haulage roadways near the shaft bottom to deal with an output of 1,500 tons per shift, from a seam dropping 1 in 4. The tubs to hold 10 cwt. (50) Only a small majority of the candidates showed the connections between the main haulage roadways and the shaft sidings. On the whole the sketches were not very satisfactory. (2) Discuss fully the advantages and disadvantages of placing an endless rope haulage engine on the surface, compared With installing the engine underground. (40) The pros and cons for placing an endless rope engine on the surface were fully discussed. The principal conclusion arrived at was that a high class steam engine could be used on the surface as against electricity or compressed air underground. The advantages given of an underground installation, however, outweighed the advantages of a surface installation. (3) Sketch and describe what you understand by the following: (a) Fault; (b) reversed fault (c) roll; (d) dyke ; (e) fissure (f) syncline; (g) pot hole; (h) Wash-out. (40) This question was well answered. (4) With machine mining at the coal face, under What conditions is it desirable to install a gate-end loader, or a gate-belt conveyor? Under What conditions does the gate-belt conveyor justify the additional cost over the gate-end. loader? (40) The conditions which would be more suitable for one type rather than the other, were not too clearly stated. For instance, if a large main road has to be maintained, a gate-belt conveyor is not as advantageous as if a small road sufficient for the belt is all that is necessary. (5) Under what conditions Would you use rigid guides in a shaft? Which type do you prefer, wood or rail, and why? Show by sketch how both types are secured in the shaft. How far apart would you place the bearers or buntons? (40) The conditions under which rigid guides in a winding shaft would be preferable to flexible guides, were understood. The sketches, however, were not very satisfactory. (6) It is now established that sand is better than clay for stemming shotholes. What are the important advantages claimed for sand? What do you consider is the best way to treat the sand so as to make it of a suitable consistency for easy handling? (40) The great majority of the candidates were familiar with the results of the experiments which have recently been carried out in the use of sand for stemming. The answers indicate that it is now fairly generally used with satisfactory results. The treatment of the sand to make it of a suitable consistency for easy handling was not too well known. (7) After sinking a shaft to a depth of 150 yds., heavily watered strata 40 yds. in thickness are met with. Describe the method you would adopt whilst sinking through this ground. (40) Practically all the candidates would, as was expected, adopt the cementation process for overcoming this difficulty, but only a few gave details as to how the method would be applied. Ventilation (1st Class). (1) On the plan which accompanies this paper, show how you would arrange the ventilation. This is a plan of a pit bottom of a large modern colliery working a fiery seam and employing about 1,200 men in four large districts of nearly equal size. Winding is carried on at both shafts. Show how you would arrange the ventilation of this colliery, marking the direction of each air-current, and the positions of all air-crossings, doors, stoppings, regulators and sheets, using only the signs laid down in the regulations. Colour the path of the return air red and that of the intake blue. The seam is level. (50) The arrangement of the ventilation of the pit bottom showed a grasp of the vital problem of distributing the air-current coming down the do downcast pit forward into the various districts, and its return to the upcast pit; very much in advance of that in previous examinations. Instead of having to report that a proportion of the candidates allowed the air to pass direct from the downcast to the upcast without traversing the workings at all, it is gratifying to report that there was scarcely an instance of this on the present occasion. The legal requirement of a second intake, the disregard of which has had to be commented on regularly, was, in this examination, complied with in almost every case. (2) A ventilating fan delivers 200,000 cu. ft. of air per min. from its evasee at a velocity of 1,000 ft. per min. The water-gauge in the fan drift is 2 in. Calculate the horse-power of ventilation. Assuming the air to weigh 0.08 lb. per cu. ft., what proportion of the energy applied to the air is absorbed in imparting the exit velocity to the air-current? If the combined efficiency of the fan and motor is 60 per cent., what horse-power would have to be supplied to the motor to produce the above quantity? (30) This question was attempted by nearly all the candidates, and correct results were usually obtained as to the horse-power, and as to the efficiency. The calculations of the energy lost in the exit velocity of the air, were, however, beyond some of the candidates, which should not be the case in the first class examination. (3) Describe fully how you would ascertain the moisture present in the air in the fan drift of a mine, giving the results of an actual case, and explain whence the moisture is derived. Under what conditions is moisture in the air of great importance, and What effect has it on the health of the workmen? (30) In most cases this question was understood and well answered, especially from the health point of view. (4) Calculate the volume in cubic feet of a ton of normal air at a temperature of 55 dog. Fahr. and a barometric pressure of 31 in. Also the volume of the same weight of air at 75 deg. Fahr. and a barometric pressure of 28 in. What would be the Weight of 1,000 cu. ft. of air at 60 deg. Fahr. and 30 in. barometric pressure? (30) A few were somewhat inaccurate through the use of the slide rule, and from using factors only roughly accurate; otherwise well answered. (5) Give a full description, with sketches, of a modern flame safety-lamp. (30) These answers were disappointing. Apart from a few good ones, sketches were poor and disproportioned. The ring securing the glass, essential for the proper assembling of the lamp, was omitted in too many cases. (6) It is proposed to sink a pair of shafts, each 18 ft. diameter, to a depth of 600 yds. Give full particulars of the plant you would install for ventilating these shafts during sinking. (30) A fair proportion of good answers showing a competent knowledge of the arrangements now used. The others were insufficiently acquainted with the subject; the correct relationship between the sizes of motor, the water-gauge, and the quantity of air was missing. Only one candidate suggested the use of air pipes of elliptical cross-section, which, in large sizes, obstruct the fairway less than circular pipes. (7) What is meant by "coefficient of friction of ventilation?" Give its value as determined by Atkinson. Discuss the variations proposed by recent authorities, giving their views. Also state what, in your opinion, can be done in practice to reduce this factor to its lowest possible value. (30) All the candidates gave a good answer to the first part of the question, except that the majority did not give Atkinson's figure correctly. The latter part was well discussed. Explosions, Etc. (1st Class). (1) What are the limits of inflammability of firedamp under ordinary mine conditions, and how are they affected by the absorption of oxygen by the coal, and any other oxidisable material present? What precautions should be taken when shutting off gob-fires in gassy seams to lessen the risk of an explosion? (30) The limits of inflammability were generally stated correctly, but the effects of absorption of oxygen were not well understood. The last part of the question was answered satisfactorily. (2) A longwall face is approaching old workings which end in a pair of parallel narrow levels; the old workings contain Water under pressure. Sketch and describe how you would approach, and drain, the water from the old workings. (25) Some candidates only showed boreholes on the advancing longwall face within the 40 yards limit, and overlooked the necessity for the narrow heading with advance and flank boreholes as required by the Coal Mines Act. Many omitted to deal with draining off the water. (3) Name the two dangerous dusts which are produced in mining operations. How can the production of these dusts be minimised, and What should be done to safeguard the mine and the workers, also to protect the health of the Workers ? (25) Generally very well answered. (4) Make a sketch plan of the method of working a seam of coal with which you are acquainted, and where precautions against gob-fires have not been considered to he necessary. Trouble from gob-fires is now threatened; show by another sketch what alteration you consider should be made in the method of working in the future. (25) Sketches were poor and incomplete, intakes were shown but no returns. Impossible arrangements were shown for dealing with coal from the faces and for ventilating. (5) Accidents have occurred to members of rescue teams when engaged in actual work underground, either through some fault in the apparatus, or some action or neglect on the part of the Wearer. Set out the principal causes of such accidents, and the precautions that should be taken to guard against them. (25) The question clearly asks for the causes of accidents to members of rescue teams when engaged in actual work underground, but a number of candidates only dealt with the importance of testing the apparatus on the surface. Others ignored the question and suggested that only gas masks should be used in rescue work, overlooking the fact that these cannot be used unless there is a sufficiency of oxygen present. The danger of not coupling up early whilst in good air and before entering the danger zone, was sometimes overlooked. (6) It is desired to reopen a district which has been sealed off by stoppings in consequence of a fire. Pipes have been placed through the stoppings for the purpose of taking samples of the pent-up gases. State approximately the analysis which would lead you to suppose — (a) that the fire is still burning, (b) that the fire is extinguished. (25) Comparatively few candidates attempted to answer this question, and the answers were not very satisfactory; they indicated lack of knowledge concerning the composition of the gases behind stoppings in sealed off districts. Management and Legislation (1st Class). (1) (Compulsory) Write a report to your directors — in two parts — embodying: (a) A description of the underground lighting at a mine with which you are acquainted. Point out the merits and defects of the lighting systems and lamps in use. (b) A general account of the investigations which are being carried out with regard to the improvement of underground lighting. (30) Most of the reports were exhaustive and very satisfactory, and many of the candidates showed that they were familiar, with the general investigations which are being carried out on the improvement of underground lighting. (2) The General Regulations relating to explosives provide that "the person firing the shot shall, before doing so, see that all persons in the vicinity have taken proper shelter, and shall also take suitable steps to prevent any person approaching the shots. He shall also himself take proper shelter" Some of H.M. Inspectors of Mines draw attention in their Reports to mistaken ideas that prevail amongst shot-firers and Workmen as to What constitutes "proper shelter," and that have resulted in serious accidents. Describe in detail what you would consider it necessary to do to comply with the regulations. (25) Most candidates discussed the meaning of proper shelter intelligently, and if their ideas were carried out in practice there would be few accidents from this cause. Some still thought that crouching behind a tub was proper shelter. (3) Give a list of the inspections and examinations of Workings and apparatus that are called for by the Coal Mines Act, 1911, and the General Regulations. (25) The question asked for a list to be given, but many candidates wrote pages of description and mixed up the inspection of workings with those of apparatus — some underground and some on the surface — in a confusing manner. The best way to answer this question was to draw up a table showing, in columns, the inspections required, the period of such inspections, and the persons by whom they were to be made. (4) What provisions in the construction of cages used for winding men and minerals are essential to comply with the Coal Mines Act, 1911, and General Regulations? (25) Nearly all the answers were complete and concise. (5) Give an outline of the provisions of the Coal Mines Act, 1911, and General Regulations as to : (a) Steam boiler; (b) engines and engine houses. (25) The provisions were generally well understood, but there was considerable confusion in arrangement and want of conciseness. (6) (a) What are the duties of the manager and of the under-manager of a mine as laid down by the Coal Mines Act, 1911 ? (b) What is meant by "daily personal supervision" ? (a) What provisions are made in the absence of the manager or under-manager on leave or from sickness or other temporary causes (d) What are the limitations as to the number of mines for which a manager may act? (25) Some candidates answered in great detail. Others appeared to put the duties down as they occurred to them, without any idea of arrangement in order of importance. The definitions given of "daily personal supervision" varied considerably. [To be Continued.]
|
|||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||