|
25th June 1932, Page: 392, Column: 2 Use Of Coal-Mining ExplosivesBy Prof. Douglas Hay, B.Sc., and Prof. R. V. Wheeler, D.Sc.* Safety in the use of explosives in coal-mining is the first practical consideration. The manner of use of an explosive, so as to ensure safety, is of more importance than the "safe" character of the explosive itself; for no explosive, by its very nature, can be regarded as inherently safe. It can be understood that the safe use of an explosive should correspond with its most efficient use; for the fact that an explosive does its work properly, in bringing down coal or rock in the most efficient manner, is the best guarantee that little energy remains for improper behaviour that might lead to the ignition of gas or dust. The Safe and Efficient Use of Explosives. The Explosive. — If possible, only one cartridge should be used in a shot-hole for a given charge. If this is not practicable, the minimum number should be used. That is to say, an 8-ounce charge should preferably be one 8-ounce cartridge, and two 4-ounce cartridges are better than four 2-ounce cartridges. The reason for this is that there is always a diminution in the explosive force developed as the detonation passes from one cartridge to another in a charge, through the folded paper at the ends of the cartridges and, possibly, across an air-gap, or a gap filled with dust, between the ends. The more often such a passage from one cartridge to another occurs, the less effectively is the charge of explosive detonated; and there is a danger lest one cartridge in the charge remain undetonated, incompletely detonated, or smouldering. The detonator should point towards the hack of the shot-hole, away from the stemming, having been inserted in the end of the cartridge (or of the primer when more than one cartridge is used) nearest to the stemming. When it is so placed, withdrawal or displacement of the detonator during stemming can be avoided by passing the leads in a half-hitch around the end of the cartridge, care being taken not to abrade the insulation of the leads. The Detonator. — On the whole, low-tension detonators are more reliable than high-tension detonators, but there is not much to choose between the two types. Low-tension detonators can readily be tested before they are issued to ensure that they are in good condition, and they can be obtained from the manufacturers graded so that the resistance of the bridge-wire does not vary much from one detonator to another. Such grading tends to ensure uniformity of behaviour. The leads should be well insulated. Stemming. — Ritson and Stafford, by their experiments for the Shot-firing Sub-Committee of the Safety in Mines Research Board, have shown that moist clay cannot be regarded as a satisfactory stemming material. Instead, they recommend a mixture of 3 parts of coarse sand to 1 of clay, ground together when dry and then moistened. A little calcium chloride (5 per cent. or less) added to the mixture keeps it moist and it can be moulded as readily as clay. We can confirm their observations. As an alternative to sand and clay, a mixture of clay and burnt shale, riddled through a ½-inch mesh, has been found satisfactory. The mixture is prepared as dry as possible and is wetted slightly before use. The Exploder. — The most frequent cause of missfired shots is ineffectiveness of the exploder. The newer types of approved exploders, incapable of producing a spark that can ignite firedamp but having ample output, should mark an advance in this respect. Cushion Firing. — Referring to "cushion firing," it is necessary to explain what is meant. An air-space is left between the charge of explosive, at the end of the shot-hole, and the stemming at the mouth. The result of such an arrangement, with a suitable explosive, is that the coal drops almost solid, to be broken up by hand, leaving the shot-hole intact. With a given charge of explosive, the insertion of a greater length of stemming, so that the length of air-space is reduced, causes the coal to be more broken up until, when there is no air-space, smalls only are produced. It will be understood that with different degrees of hardness of the coal, the length of the air-space can be adjusted so as to give the best results, without varying the weight of the charge of explosive. Similarly, when loading a given seam by scrapers instead of by conveyors, when it is desired to blow the coal over into the scraper track, suitable reduction of the air-space will give the desired result. * From paper on "Some Practical Considerations Regarding the Use of Coal-mining Explosives" read at the 94th general meeting of the Institution of Mining Engineers.
|
|||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||