|
29th November 1930, Page: 145, Column: 1 Powdered FuelIn his paper on "Powdered Fuel and a Special Reference to Lancashire Boilers," at the November meeting of the Manchester Geological and Mining Society, Mr. Hill, of Clarke, Chapman and Co., said that all pulverised fuel plants have a family resemblance, and they may be broadly divided into two classes, those working with a large combustion chamber, as in the case of a water tube boiler, and those working with a confined combustion space, as in the case of a Scotch type marine boiler, or Lancashire boiler. There is no question that the maximum fineness possible should be aimed at. This is essential in every case. Considerable variation is found, however, at different plants, and samples taken show a wide variation of 35 per cent. to 97 per cent. passing a 200-mesh. A good working percentage, however, for most coals is about 75 to 85 per cent. through a 200-mesh screen, while as small an amount as possible should be held on a 100-mesh screen, say, not exceeding 4 or 5 per cent. The same pulveriser on different classes of coal will give very great differences in fineness, and the analysis is little guide as to what the fineness will be. Hard coal may not be difficult to deal with and some soft coal is among the worst. Speaking from the point of view of the Impact Type of Pulveriser — such as the Resolutor — a friable coal is the simplest to deal with and a woody-natured coal like Durham splint among the most difficult. Moisture in the coal has a considerable bearing on the output and fineness. In modern plants, said Mr. Hill, the power consumed per ton for the preparation of the powdered fuel may he taken as 13 KW per ton upwards. Coal containing very high percentages of ash can be burnt, but it must be borne in mind that the ash is not destructible and has to be handled and disposed of. In addition, it has to be brought to the pulverising plant and possibly stored in bunkers to the detriment of their useful capacity, and also pulverised along with the coal. This means additional power for a given number of B.T.U.'s and also increased wear and tear. Owing to variation in types of coal and ash it is very difficult to name a figure for the cost of renewals, which, of course, in addition to the cost of power taken by the pulverising and distributing plant, must be added to the price of the coal. The percentage of ash in the coal must be considered from a number of points of view, such as the means of disposal, cost of transport, behaviour of the ash in the fire and wear and tear. Messrs. Clarke, Chapman have been informed that the plant at Craghead Colliery, Durham, belonging to Messrs. The Holmside and South Moor Colliery Co., is one of the few working continously. The installation originally consisted of the application to six boilers each 30 feet by 8 feet and was started up at the beginning of August, 1928. As a result of the successful operation over a period of 13 months another installation was ordered for two additional boilers of the same size, and this has now been working since the early part of this year. At this colliery there are few very light load periods, as when steam is not required for drawing coal it is passed to the turbines in the power house, and under normal conditions of trade the boilers are working continuously. The coal burned is kirvings, with a mixture of belt pickings which are crushed and mixed with the kirvings. Prior to the installation of the powdered fuel plant a good class of saleable coal was used. The powdered fuel installation was able to maintain the steam pressure using the very poor coal. The boilers are fixed in pairs, that is to say, one pulveriser is fitted to supply two boilers. The nominal output of each pulveriser is 30 cwts. per hour. The raw coal is fed from the bunkers directly into the pulverisers which are of the Resolutor Type. From the feed gear the coal passes to the pulverising chamber. Here pulverisation is accomplished entirely by impact by means of a single disc provided with fixed heaters. Following further particulars of the plant and a reference to the saving of 15 to 18 per cent. in the case of ships using powdered fuel, Mr. Hill said that in the ordinary way when considering any coal to be burnt in pulverised form, the first figure of interest is the volatile content. With bituminous coals this is more or less a matter of comparison, but when volatiles below (say) 15 per cent. are being considered the problem is different. This was brought home when trying various anthracite coals, and it was found that while a coal containing 12 per cent. of volatiles gave good results as long as the furnace temperature was kept well up, another sample containing 15 per cent. gave most indifferent results. In the author's opinion, this might be accounted for by the coal containing 12 per cent. total volatiles having a fair percentage of lighter fractions which would commence combustion, so obtaining the necessary heat to ignite the remaining volatiles, whereas, in the case of the coal containing 15 per cent. volatiles, possibly all the volatiles came off at the usual test temperature of 750° to 800°. If some standard of temperatures could be fixed, possibly three in number, so that the character of the volatiles could be seen at a glance, it would be of the greatest assistance in considering the possibilities of dealing with coals having low volatile content in powdered form.
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||