|
13th July 1929, Page: 408, Column: 2 Electrically Driven LocomotivesAt the recent general meeting of the South Staffordshire and Warwickshire Institute of Mining Engineers underground haulage and conveying methods were discussed. Mr. C. F. Jackson (the president) introduced the subject with some remarks on the possibilities of electrically-driven locomotives for the haulage of coal to the pit bottom. There were two types of these locomotives, those which ran on the same system as tramcars that drew the power from a bare overhead wire, and those which were run from accumulators. In American mines the bare wire was used in some cases. The risks were obvious — the danger of a spark, and the possibility of an employee touching the wire. It was considered in the United States, however, that main haulage roads should be sufficiently well ventilated to do away with the first danger, especially if they were well stone-dusted. A man who had been there said, as regarded the risk of an employee electrocuting himself, the Americans took the view that "if he had no more sense than to do such a thing, he was best dead." That might be their point of view — it was not ours. The disadvantage of the accumulator system of power was that it could not deal with the gradients possible of negotiations by the bare wire system. A comparatively flat haulage road was necessary. There was no doubt that by means of the bare wire many advantages could be gained, especially in facilitating men getting quickly to their work when they had descended the shaft. The cost of installing electrically-driven locomotives of either type, was not serious when compared with that of installing and maintaining the more cumbersome haulage system in common use in this country. Even the endless-rope system, with its undoubted capacity, could be outdistanced by the use of a couple of locomotives. It was estimated that a locomotive run from batteries could be put in at a cost of £1,811. He was not suggesting the use of locomotives drawing their power from the bare wire for use in this country, but he thought a case had been made out for the use of the accumulator-driven type on level haulage ways. Mr. L. Holland said he remembered seeing a very good system at Ebbw Vale. Accumulator locos were used in that case. There was an adit, but the Mines Inspector considered that an adit was the same as a shaft and, therefore, the cables must be covered in double-wire armour, and that, of course, ruled out the overhead conductors. The experience there bore out what Mr. Jackson had said in regard to cheapness and flexibility. Capt. R. C. Smart, in a written contribution on electric-locomotive costs, gave an instance of a 3-ton locomotive and auxiliary equipment costing £1,625. For this locomotive the annual capital charges per day amounted to 15s. 5d.; driver's wages, 8s. ; renewals on locomotive, 1s. 8d, ; stores (oil, waste, etc.), 10d. ; distilled water for battery, 6d. ; power for 27 trips, 35 units at 1d., 2s. 11d., making a total of £1 9s. 8d. On this basis the cost per ton of coal delivered (486 tons) was 0.735d., or 2.08d. per ton-mile;
|
|||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||