18th May 1929, Page: 340, Column: 2
Roof Control
In the continued discussion at the April meeting of the North of England
Institute of Mining and Mechanical Engineers, on the paper by Mr. J. F. C. Friend
on "Roof Control on Longwall Faces," Mr. A. C. Walker
said that however they might systematise their knowledge of roof
control a great deal always depended in practice upon the observation and
judgment of the officials operating the faces. A very slight change in almost
any of the factors — a change too slight to notice upon casual
observation — would produce very unexpected results. For example, the
existence or non-existence of a coal parting of only ¼ inch in thickness
might make all the difference between the success and failure of a system. An
example of the wide difference in the behaviour of strata under similar
conditions of working which came to his notice was that of two roads driven in
the same seam, only 500 yards apart, both supported by 10 ft. by 8 ft. steel
arched girders, one of which was renewed five times, while the other needed no
repairs at all. It was desirable, that the movement of the faces should be as
rapid and as regular as possible, but with additional face support they found
that under a very weak roof as little harm was done in standing for a week as
was done by standing for a week-end. The secret of successful roof control
seemed to Mr. Walker to lie in machine work with the use of steel
supports, as in practice they found that a main break; was formed in the roof
immediately after cutting, the break not being visible, but existing as an
incipient fracture. Using steel supports and supporting this incipient fracture
on the centre of the straps, advantage could be taken of this fracture. With
hand hewing this incipient fracture was not present; the face was never in a
straight line, and settlement of the roof was always a haphazard affair.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Friend, J. F. C. | | | |
| Walker, A. C. | | | |