|
18th May 1929, Page: 347, Column: 1 X-Ray Analysis Of CoalThe arrangements for the meeting on the 20th of April of the North of England Institute of Mining and Mechanical Engineers, included the reading of a paper by Mr. C. Norman Kemp on "The X-ray Analysis of Coal : the Radiographic Variables and their Control," his object being to give some indications as to the directions in which the X-ray investigation of coal is proceeding. He was entrusted with a comprehensive research on the uses of X-rays for the examination of coal on behalf of the Fuel Research Board of the Department of Scientific and Industrial Research. After a considerable amount of general preliminary work had been carried out, a number of blocks of coal of various sizes and thicknesses were selected at H.M. Fuel Research Station, and he subjected these to radiographic examination in order to determine (1) the degrees of detail to be observed in comparatively thick masses, and (2) the thickness most suitable for a detailed examination of the character and distribution of the inorganic constituents. It was found, according to anticipation, that a good general impression as to the banded structure can be obtained from such an examination of blocks up to several inches thick under certain definite conditions: (1) That the bands are of some thickness, and reasonably regular and parallel. (2) That the direction of the incident radiation is parallel to the average direction of the bedding-planes. (3) That the upper and lower surfaces of the specimen are approximately flat and parallel. Broadly speaking, the results of tests served to show that radiographs of coal several inches in thickness provide a certain amount of general information as to the banded structure and the relative transparencies or opacities of the bands depicted. This may suffice in particular cases, but does not ordinarily permit of a detailed study of the bands or of associated impurities. If we consider in detail the steps involved in the final reproduction of an X-ray photograph, Mr. Kemp says, it will be found that each of the following factors requires to be considered and controlled :— I. Relating to the Specimen. — (a) Thickness. (b) Orientation. (c) Distance from radiating source. II. Relating to the Radiation. — (a) Penetrating power or "quality." (b) Intensity of "quantity." (c) Duration of incidence. III. Relating to the X-ray Film. — (a) Type of film. (b) Com- position of developer. (c) Temperature of developer. (d) Time of development. IV. Relating to Final Reproduction. — (e) Method of printing from negative. (e) Method of reproduction from positive. Experiments now in progress, says Mr. Kemp, lead to an instrumental observation instead of a visual comparison. For this purpose advantage is taken of the improvements in the construction and properties of modern selenium cells. The source is a 100-candle-power Pointolite lamp, the light from which is passed through a condenser and diaphragm, and then through the optical wedge, the position of which may be varied and measured. The transmitted beam passes through a lens and thereafter falls upon the surface of the selenium cell, which is connected in series with a battery of accumulators and a suitable moving-coil galvanometer. The needle movements are proportional to the resistance changes of the cell, and thus the electrical instrument may be calibrated in relation to the optical wedge, and the density of any portion of a radiographic film determined by direct reading. The arrangement indicated is so simple that its possibilities in the present connection are being thoroughly examined. In the case of areas in X-ray photographs exhibiting little or no differentiation, erroneous conclusions might be drawn from a comparison of radiographs resulting even from successive equal exposures to rays from a "gas" tube owing to the tendency of this type to "harden" in use, i.e., to emit rays of increasing penetrating power. This difficulty is now met for the first time in the case of coal by taking advantage of the characteristics of the hot-cathode tube, and an endeavour will be made to establish a standard of comparison consisting of pure carbon, so that the effects of variations in ash-content in regions containing only inherent ash may be investigated. The Author referred to a paper read at the Edinburgh Coal Cleaning Conference on "A Consideration of Certain Problems encountered in the Preparation of Coal for the Market," in which Dr. F. S. Sinnatt observed that the broad question involved appeared to be the need for an insight into the properties of coal-seams in relation to the characteristics of the commercial grades of coal. Dr. Sinnatt indicated, further, that information is at present lacking and is to be desired regarding a number of points which he dealt with in detail, as follows: (1) Individuality of seams. (2) Relation between chemical and physical properties. (3) Recognition of impurities. (4) General and local variations in composition. (5) Properties of layers in seams. (6) Mode of fracture of layers in seams. (7) Detection of certain constituents in layers. Mr. Kemp says it may be suggested with confidence that radiographic methods are capable of contributing to the further study involved in the elucidation of many coal problems which intimately affect industrial progress.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||