20th April 1929, Page: 309, Column: 2
Supports For Mine Workings
At the February meeting of the South African Institution of Engineers, in a
paper on "Sand-filled Members as Supports for Mine Workings,"
Professor W. J. Walker and Mr. S. F. Gimkey gave the results of
experiments carried out at the University of the Witwatersrand to test
telescopic arrangements of concrete tubes and steel tubes for use in mine
workings. The whole object of the investigations is the provision of suitable
"hanging" supports which will replace wood as far as possible, and,
while being cheaper, yet possess the valuable property of gradually yielding to
a moving load without sudden and treacherous collapse. Concrete supports, per
se, can scarcely fulfil this function, as is recognised by the provision of
12-inch to 18-inch chocks at the heads of all concrete pillars, whether
monolithic or constructed of superimposed slabs. The paper is given in full in
the journal of the institution, and the Authors say there is no doubt that,
were the supports for underground workings of sufficiently standardised nature
such that their appearance and condition could be taken as approximately
reliable indication of the loads being carried, valuable information would be
available regarding rock movements in any mine. This does not appear to be an
impossible ideal after which to strive. There are, broadly speaking, two
general methods by which a structural member may be designed to withstand
compression. First, by the choice of a material which has a high compressive
strength, sufficient cross-sectional area of the member being provided to
withstand the compression load imposed. This is the principle of the concrete
pillar or slab support. On the other hand, the member may be constructed of
tubular or hollow form, the interior of which is filled with fluid or granular
material, the latter taking the compression load through the intermediary of
plungers at the extremities of the members. In this case the criterion of
failure will clearly be, in general, the tensile strength of the material of
the tubular member. For fluid material the ratio of lateral to longitudinal
stress along the member will be unity, but for granular material it will be
considerably less, and therein lies the value of sand or other granular
filling. Confined sand or other granular material forms excellent foundation
material, i.e., material capable of withstanding high compression loads.
Examples of buildings and super-structures erected on quicksands surrounded by
sheet piling are well enough known as testimonials to its efficiency. The
Authors say the experience and information obtained during the progress of the
tests may be summarised as follows : (a) Sand-filled reinforced concrete, or
steel tubular or ring members, are stronger and less treacherous supports than
"pancake" supports. The tension strength of the reinforcement in the
concrete pipes or rings is their final criterion of failure. Before failure of
this reinforcement, the sand or granular material is already packed so tightly
that sudden collapse never occurs, (b) The telescopic form of support, by a
more uniform distribution of sand pressure along the column, provides more
compression or "give" than a single pipe support; this
"give" and, therefore, the consequent strength of the column, is
considerably increased by sharpening the edges of the smaller internal
sections, (c) The best form of reinforcement in every case for concrete pipe or
ring columns would appear to be a pure spiral wire reinforcement, the ends
being finished off to allow of free expansion of the spiral as the sand
pressure increases. This free expansion, of course, can only occur after the
disintegration o! the concrete, (d) The reinforced concrete "ring"
form of support is the strongest, aud would appear also to possess the
advantage of being the most economical type. Existing "pancake"
plant, with slight modification of moulds, could be utilised in their
manufacture.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Gimkey, S. F. | | | |
| Walker, W. J., Prof. | | | |