|
23rd March 1929, Page: 276, Column: 1 Gob-FiresBy F. E. Stone. From paper read at the February meeting of the Barnsley Society of Mining Students. Mr. Stone is a Sub-Inspector of Mines in the Yorkshire Division. Before a gob-fire is possible two essentials are necessary : (1) A supply of combustible material in such a form that air can act upon it must be present in the goaf. (2) A supply of air in or passing through the goaf. (1) A gob-fire, as the name implies, occurs in the waste of long-wall workings, that is an area from which the seam has been worked. How then can we have combustible material in the goaf ? Mining men, particularly at the present time, are inclined to think of combustible material in terms of good clean coal only, but we must not forget that many wastes are rich in combustible material. In many cases a portion of the seam has been left up to form a roof. During the working of the seam small ribs of coal may have been left to form goaf at places where the roof has collapsed right up to the face. Inferior coal may be left along fault sides. In the roof of many seams there are thin seams of coal. Bearing all this in mind and also remembering that many roof shales are rich in carbon, it will be easy to realise that practically all wastes contain much material of a combustible nature. (2) The supply of air comes, of course, from the ventilation of the mine. Ventilation is necessary for health and safety and cannot be avoided. Allowing the air to travel through the goaf is quite another matter, and must not be permitted in any mine subject to gob-fire. The originating cause of the self-heating of coal, or spontaneous combustion, as it is now termed, has for many years occupied the attention of mining men, chemists and scientists. Various theories have been put forward but none has met with universal acceptance. It is, however, now recognised that the main cause of spontaneous combustion of coal is most often the direct action of the oxygen of the air on the coal substance. The heat in the goaf may, and sometimes does, attain a temperature sufficient to cause ignition of the combustible material. Assuming the conditions are such that the goaf temperature is rising to a point at which a fire may be imminent or even in existence, the following signs are put out in the order named : (a) Rise of local temperature, (b) Sweating of the ground in the vicinity of the fire, (c) Gob-stink, (d) Smoke. (a) The goaf and packs in the affected area are noticeably warmer than the usual "run" of the district. The air near the edge of the goaf is somewhat oppressive, and the atmosphere in the neighbourhood of the heating becomes muggy. (b) The air meeting the exposed surfaces after leaving the hot goaf often deposits moisture on the roof and sides. This moisture, similar to dew, is termed sweating. (c) Gob-stink is the name given to the peculiar smell given off by the gases emerging from a heated goaf, and said by many to be an indication that the goaf temperature is sufficient to cause ignition. The smell is peculiar and characteristic, and similar to the smell one gets when near the distillery of a coke oven plant. Men trained in the detection of gob-fires are seldom mistaken as to the meaning of this gob-stink, and they can form a good idea as to what stage the heating has reached. (d) Smoke requires no explanation, and gives an unmistakable warning that a fire is actually in existence. If the signs are convincing that a fire is probable it is imperative at once to deal with the threatened danger. To delay action against any unwanted fire tends to make matters worse ; quick attack must be the rule in all fires. We have two essentials necessary. We must at least remove one of these before the fire can be quelled. Essential No. 1. — Combustible material. To remove the heated material is known as filling out. This is often attempted and carried out successfully. Essential No. 2. — Dealing with a heating by cutting off the supply of air is known as sealing off. To hasten the extinction, water or inert gas may be poured into the area sealed off. The choice of method depends upon many circumstances, and it is often a matter of opinion which is the best way. If it should be decided to fill out, the work is commenced by driving narrow but reasonably high scouring directly into the fire. The scouring must be well secured by steel supports and plenty of sand or stone dust for quenching the hot material should be on hand. All heated material should be sent out of the mine. The work is very exhausting but must be carried on without cessation. This means relays of workmen. Each relay of men should work and rest to a fixed time, the extent of which depends upon circumstances. Every effort must be made to have the work properly organised both at the scouring and along the roadways so as to facilitate transport of the materials required. Plenty of drinking water should be provided for all concerned. Reviving apparatus, ambulance requisites, and, if possible, a telephone should be quite near the men engaged on the task. When all the heated material has been removed the goaf should be allowed to remain open a short time to cool down and then be stowed up with sand, soil, or other suitable material. Sealing off is often carried out when a heating is detected within a waste where the goaf has not settled down. The packs are reinforced by sand, and a stout stone pack, with plenty of sand within it, is built across the waste. The latter pack is joined up to the roadway packs, so as to completely enclose the suspected area. The face is then worked quickly and evenly, the whole effort being to direct the roof weight so as to compress the goaf over the fire. Where the fire cannot be filled out nor the goaf pressure be employed it may be necessary to seal off by putting substantial dams at a point some distance back from the fire. This may mean the closing down of a large portion of the mine, as the stoppings may be put at a point where the ground is free from fracture. In seams liable to fire a method of working is generally adopted which lends itself to the ready sealing off of an area or panel of work without affecting other portions of the mine. All fire stoppings must be substantially built and be well "let" into the floor, roof and sides. Pipes are often built in the stoppings for use later. Samples of the gases behind the stopping can be drawn through the pipes. Inert gases are sometimes forced through pipes through the stoppings so as to endeavour to ensure a more rapid extinction of the fire. Drowning out means the flooding of the fire area by water. This is undoubtedly the best method of dealing with a gob-fire, but unfortunately it is rarely possible to make use of this method, especially in South Yorkshire. The fire may be on the rise side of the pit; an area where water has been used and then drained off is very liable to again become heated. It may be said that water can only be used in a dip area which is exhausted, and from which the water need not be pumped, unless the circumstances are very unusual. Combustible material must be present in a suitable form in the goaf before a gob-fire is possible. It is very difficult to avoid combustible material being present in the goaf, but it may be done by stowing all suitable dirt in properly built packs. Dirt from road repairs should be sent inbye and used to strengthen the packing. The withdrawal of all back timber must be strictly enforced. Such timber, whilst perhaps not so important from a combustible matter point of view, is a real danger. It should be borne in mind that timber in a heated goaf is liable to give off flames, whilst the gases arising from the charring of timber are very unpleasant and cause intense smarting of the eyes. All ribs of coal should be removed before they become part of the goaf, and all fault sides should be stripped clean even if the coal is of no commercial value. Paces that have to stand for any length, of time should be kept clear of fallen coal, lest the roof should, collapse and bury loose coal. Supply of air in the goaf, without which no gob-fire can commence or continue. It is with this essential that most of the present day efforts are made. To keep the air from the goaf, we must endeavour to work the face in straight lines with continuous advancement. Regular building of good packs, with each pack well topped up to the roof, including the roof of any cavity, and all roadside packs joined up, is of the utmost importance. Solid packs of not less than five yards thick along rib sides and fault sides with sand packed immediately against the rib or fault. All packs should be built as soon as the pack area is available, but care must be taken to avoid building the packs too near the face as this tends to divert the air into the goaf. All airways must be of ample area, as direct as possible with through connections apart from the actual working face. This is of the utmost importance should a fall occur on the face, the air can at once be coursed up and down the gates and not forced through a narrow road over the fall. Falls at the face are to be avoided as much as possible, and when one does occur all the coal against the fall must be extracted. A solid pack under the good roof, and joined to the gate packs so as to enclose the fallen area, is a good safeguard. Discontinued roadways should have the timber withdrawn and be completely stowed with solid sand and bind packs across the ends of the roadway. All these arrangements are desirable, as they help to confine the air to its proper path along the roadways and across the working face and to prevent it travelling through the goaf. Further, to consolidate these efforts the roof is ripped as quickly as possible in all gates, crossgates and main roadways to a height sufficient to enable the packs to be completely buried. Usually the packs are buried thirty to sixty yards behind the face. Abundant supplies of stone dust should be spread along every roadway, right up to the working face. Coming now to the withdrawal of timber, a point so often mentioned in seams where gob-fires are feared. It is from the supply of air point of view that back timber is dangerous. If props are left standing in the goaf it means that the roof breaks all around and forms cavities. These cavities hold air and so increase the liability of heating. Props left standing in packs break and often cause the displacement of the packing with serious results. These remarks apply to steel equally with wood. In a seam liable to gob-fire it is wise to have a trained fire staff. Such a staff would consist of experienced men under a special official and, subject to the manager, would confine their attention to matters appertaining to gob-fires, more especially in taking steps to prevent heatings. A special staff would deal with matters requiring special care, such as taking and recording goaf and face temperatures, seeing that supplies of sand, soil, stone dust, etc., reach the proper destination. Systematically follow up all places where face falls have occurred, take temperatures for several weeks and keep records with a view to taking immediate action should the slightest symptoms of heating arise. Give an oversight to cleaning and packing off all rib sides and fault sides, and the stowing off of all finished roadways. See to the provision of an adequate supply of such material as steel for supports, covering plates, ventilation pipes, etc.
|
|||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||