26th January 1929, Page: 213, Column: 2
Proposed System Of Survey
In his paper on "Co-ordination of Mining Surveys with the Ordnance
Survey," before the North Staffordshire Institute of Mining Engineers,
Major D. A. Hutchinson says the system of survey which he would like to
propose is on the following lines :—
(1) That colliery surveys should be based on a system of coordinates parallel
to those of the local Ordnance Survey meridian. A local false origin would, of
course, be used. The conversion of co-ordinates from the Ordnance Survey data
would then be a simple matter of the addition or subtraction of a constant, the
value of which would depend upon the position of the false origin.
(2) Instead of checking the collier survey by detail on traces or plans, all
checks would be carried out by resection from Ordnance Survey trigonometrical
marks.
Provided sufficient upstations were available, it would not be even necessary
to carry out a triangulation for the colliery survey. Re-section gives
extremely good answers, so that if the position of any particular point were
required, it would be necessary only to send out an observer to take the
requisite round of angles. Under these conditions, the expense of measuring a
base and observing a chain of triangles would be done away with. It is for the
chief mine surveyor to decide the most economical methods to employ. In all
probability, they would be a combination of re-section and triangulation,
depending, of course, upon the nature of the ground.
(3) Surface detail would no longer be used for checking. This might be added to
the mining survey as required by a few measurements from fixed points and
enlarging from the 1/2500 plans.
(4) Compass bearings would, of course, be referred to the grid North. A
suitable method of doing this would be to compare compass bearings with the
known grid bearing of two points on the colliery survey.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Hutchinson, D. A., Major | | | |