29th December 1928, Page: 188, Column: 1
First Stage Of Coke Formation
From experiments recently made, as stated by G. W. J. Bradley and
R. A. Mott at the December meeting of the Midland Institute of Mining
Engineers in their Paper on "Assessing the Value of Coking Coal," it
has been shown that the first stage of coke formation from fine coal is the
extrusion, from each particle, of oil (tar) which wets its surface and spreads
over it to form a film. The tar films then cohere, and the force of surface
tension causes the coal particles to pack together more closely to form a
"cake," this operation causing the contraction observed. If the
forces causing contraction are sufficiently strong, and the shape and variation
in size of the particles are suitable, the free spaces between the particles
can be eliminated and the cohesion of the oil films (later decomposing to
produce a pitch, and finally a carbon cement) will cause the coke produced to
be sufficiently resistant to shattering. When the coal particles swell, the oil
films around each are forced together, and the mechanical pressure due to the
confinement of the swelling coal (in coke-oven practice) aids the forces of
cohesion. It is probable that with most well-known good coking coals the
pressures produced are sufficient to cause actual coalescence of the coal
particles, such as would produce their apparent fusion and perhaps impart the
vitreous lustre typical of Durham cokes, for example, as compared with the dull
and granular-looking cokes from the "Hards." It is possible,
therefore, by the operation only of forces causing contraction to produce a
coke (which may be pictured as a collection of discrete particles set in a
carbon cement) that is resistant to breakage by impact, but which would be
liable to abrasion such as would shear some of the external particles out of
their "setting." Swelling of a coal, on the other hand, by producing
actual coalescence (intermingling of the molecules of different particles),
would produce a more homogeneous coke, such as would not be so liable to
abrasion. From a comparison of the "shatter" and "abrasion"
indices of oven cokes with measurements of the phenomena of contraction and
expansion which are exhibited during coke formation, in the simple laboratory
test described, good correlation can be effected in the cokes and coals
examined. The determination of the contraction ranges (and percentage
contractions) and the expansion ranges (and percentage expansions) gives a
simple method of assessing the value of coking coals.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Bradley, G. W. J. | | | |
| Mott, R. A. | | | |