15th December 1928, Page: 168, Column: 1
A One-Man Borehole Outfit
In a paper read before the Society of Engineers on the 3rd December,
Mr. F. H. Mackintosh said that considerable value attached to a boring tool which
enabled anyone to make his own boreholes unaided and at a few minutes notice.
The principle of the tool lies in the property inherent in clays and similar
substances of flowing laterally under pressure. The tool makes a hole about one
inch in diameter, but as this hole is made solely by displacing the material,
no debris is brought to the surface, consequently no disfiguring spoil heaps
mark the sites of the boreholes. The speed with which this can be used is also
an advantage ; a score of holes averaging 30 feet may be made in a day's work
at no further cost than the operator's time. By far the greater advantage lies
in the fact that the operator by doing his own drilling thereby gains a much
better idea of the sequence and condition of the strata than the perusal of the
most accurately worded log could possibly allow. The tool can be used in
situations where a drilling rig would be out of the question. In spite of the
smallness of the hole a core sample can be obtained which is amply sufficient
to enable a stratum to be identified. The speed of penetration varies according
to the nature of the ground. In marsh clay, holes 48 feet deep have been made
in 12½ minutes, whilst in tough London clay 30 feet might take half an
hour. The tool depending as it does on the tendency of certain materials such
as clays, coherent sands, brick earth, and the like, to flow under blows or
pressure, cannot penetrate ground which does not respond to these. For
instance, it will not penetrate rock, and although gravel and shingle can be
penetrated it is hard on the rod but harder still on the operator, owing to the
pebbles falling in, and by exerting a "cam-like" action on the rod
not only retarding penetration but rendering it very hard work to withdraw. The
weight of an outfit, which includes all the tools and 48 feet of rods, is about
90 lb.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Mackintosh, F. H. | | | |