1st December 1928, Page: 147, Column: 2
Steam Raising
Before the South Wales branch of the Association of Mining Electrical
Engineers, Mr. Sidney B. Haslam read a paper on "Modern Methods of
Steam Raising, with special reference to Pulverised Fuel." He said it was
claimed for pulverised fuel that any class of coal could be successfully burnt,
irrespective of ash and volatile content, but he submitted that this was too
wide a claim and that the firing of fuel in powdered or pulverised form was
limited economically to bituminous or high volatile coal. Makers of mechanical
stokers put forward claims of just as wide a nature, but the author suggested
that with soft coals of high volatile the pulverised fuel system would show
economies while with harder coals and lower volatile contents mechanical
stoking would still more than hold its own. There were undoubtedly advantages
in both systems and it was for them to see if these advantages could be
increased in a combined system of firing. With high-class coals, a light fire
on the grate, moving at the slowest possible speed would give the best results
when just keeping up the pressure, and the immediate results of opening the
burners would meet the demands for steam for peak loads without the losses
which would ensue if the fire on the mechanical grate had to be operated in the
usual way. If low-class coals were being used, it would be necessary and
advantageous to bank on the pulverised fuel burners. It was claimed that
evaporation could be doubled by adding one or two burners over an existing
mechanical grate. It should be remembered that the chief maintenance costs of
mechanical stoking were due to a varying load, and these costs would be
considerably reduced with the steady load of the combined system.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Haslam, Sidney B. | | Mining Electrical Engineer? | |