17th November 1928, Page: 144, Column: 2
Geological Sections
Making some observations on the proposed Standard Notation for Geological
Sections before the South Wales Institute of Engineers, Professor George Knox,
F.G.S., said that in the construction of sections, the following
general rules might be observed : (a) Beds should be indicated by ruled lines
right across the section. (b) Symbols representing the composition of the bed
should not extend right across the section except in the case of important beds
such as coal seams, ironstone pins, etc. This enables even the thin beds in
small scale sections being shown without the confusion resulting from shading,
(c) All the symbols, with the exception of that for carbonaceous shales, should
be drawn freehand on small scale sections, so as to assist in bringing out the
contrast between the beds, (d) Scales should be standardised to, say, 40, 20,
10, 5 and 1 foot to 1 inch respectively, depending upon the use to which the
information is being supplied. The depth of section should be shown on one side
in feet and decimals of a foot, and the thickness of the beds on the other side
in feet and inches, or if preferred, similarly to the total depth in feet and
decimals of a foot, (e) In reproducing sections for publication reduction
should be made from a standard scale section sufficiently large to permit of
the symbols being drawn, and reduction should never be too great to confuse the
symbolic representation of the thinner beds. (f) If the vertical shading for
fireclay be discarded for the rootlet symbol, the vertical shading could be
employed for ironstone and thus prevent confusion on small scale plans.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Knox, George, Prof. | | | |