3rd November 1928, Page: 113, Column: 1
Permissible Blasting Units
One phase of the safety work of the U.S. Bureau of Mines, as explained by
Messrs. L. C. Ilsley and A. B. Hooker in Technical Paper 429 on
Permissible Single-shot Blasting Units, is the investigation of single-shot
blasting units for permissibility. The need of a safety schedule for
single-shot units may not be evident to the ordinary user, because the units
are small and the possible dangers accompanying the use of non-approved types
are not generally understood. There are two general types of these units. In
the one the electrical energy is supplied by a battery of the storage or the
dry-cell type ; in the other the electrical energy is supplied by a small
magneto-type generator. Tests made by the bureau have shown that an unapproved
battery-type unit may present at least three possible sources of danger : (1)
It may have such a combination of current and voltage that it may produce
sparks intense enough to ignite an explosive mine atmosphere ; (2) the battery
terminals may not be properly covered or protected, and consequently may allow
accidental electric contact and premature firing of the shot; and (3) the user
may be burned by the spilling of the battery electrolyte. Points to be observed
in the maintenance of permissible single-shot blasting machines are as follows
:—
Proper maintenance of a battery-type unit includes (1) keeping the battery in a
proper state of charge ; (2) keeping the battery, especially the gas vents,
clean and the electrolyte at the proper level to prevent spilling ; (3) keeping
the unit dry so that the plug and receptacle parts will not swell or warp
enough to make the plug stick in the receptacle ; (4) keeping the whole unit
free from grounds; and (5) keeping the leading wires in good condition and
attaching them properly to the plug, so as to prevent possible short circuits
and grounding to the battery casing.
Unlike a battery, a magneto does not periodically lose its capacity and does
not need recharging. However, to insure satisfactory service from a magneto
blasting unit, the magneto should receive proper care, including periodic
inspection and cleaning; it should be kept in a cool, dry place preferably
outside a mine, should not be subjected to sustained vibration, should not be
taken apart, and should not be operated when its terminals are short-circuited.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Hooker, A. B. | | U.S. Bureau of Mines | |
| Ilsley, L. C. | | U.S. Bureau of Mines | |