22nd September 1928, Page: 75, Column: 2
Corrosion in Boilers
Mr. L. O. Gunderson, in a recent issue of "Industrial and
Engineering Chemistry," deals with the subject of electro-chemical
polarisation for preventing corrosion in locomotive boilers. The author states
that four of the leading railways in America have tried the process and one of
them has as a consequence adopted it as a standard equipment on all its
locomotives. The process involves the use of two completely insulated
electrodes, these being inserted in the boiler shell, one in the upper part of
the boiler and one diagonally opposite in the lower part. The conducting
members of the electrodes are connected to iron anodes extending longitudinally
practically the entire length of the boiler, and submerged in the water while
rigidly attached by insulating clamps to the boiler shell. Insulated wires
connect the electrodes to a shunt from the headlight turbo-generator with
suitable control apparatus placed in the driver's cab to provide about two
volts, with two or three amperes to each electrode, making about 0.002 ampere
per sq. ft. of protected surface. The negative pole of the generator is
"earthed" to the boiler shell, which permits the current to travel in
the circuit from anodes through the boiler water electrolyte to the boiler
metal, through which it completes the circuit to the negative busbar of the
generator. A soluble arsenic salt is added to the boiler water at the rate of 2
lb. for the initial charge, and 1 lb. every two weeks while the locomotive is
in service. This permits the plating out of the arsenic secondary cathode,
which is the one important essential of the polarisation effect that makes the
process a success. All forms of corrosion have been prevented for nearly four
years in locomotive boilers equipped with this device, whilst contemporary
unprotected boilers have failed from pitting in less than a year.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Gunderson, L. O. | | | |