25th August 1928, Page: 33, Column: 1
Electric Cap Lamps
There are two types of approved electric cap lamps used in Alabama (alkaline
and acid battery lamps), according to Mr. Frank E. Cash, in Serial No.
2859 of the U.S. Bureau of Mines. In the Alkaline-battery Lamp the battery
consists of two alkaline-solution cells enclosed in a non-rusting container.
The container top is hooked or hinged on one side, locks on the other by a
spring, and is unlocked with a key. The two cells have a rated capacity of 12
ampere hours at 2.6 volts. A minimum amount of solution spillage is obtained
from valves in the top of each cell. The double cable insulated from the
battery to the metal headpiece is protected where it enters the battery
container and headpiece by steel coil springs to prevent breaking at the two
connecting points. The metal headpiece contains the bulb inserted behind a lens
which is held in place by a ring container lead sealed to the headpiece. The
headpiece is so constructed that if the bulb breaks the contact is
automatically broken. The total weight of the lamp is 5 pounds and 4 ounces. In
the Acid-battery lamp the battery consists of two-lead plate cells separated by
and enclosed in a vulcanised hard-rubber container. The insulated
rubber-covered cord leaves the battery at the top and side and enters the
rubber headpiece. This headpiece contains two bulbs, one for a working light
and a smaller bulb for emergencies. The current can be switched from one bulb
to the other, or cut entirely off by a switch on the side of the headpiece. A
lens is held in place by a ring container lead sealed to the headpiece. In his
summary Mr. Cash says the lamps give enough light and are, from a point
of lamp operating and maintenance cost alone, as economical as open lights ;
they cause much less lost time than do open lights ; and from a safety point of
view, the argument is practically all in favour of permissible electric cap
lamps for use underground. On the other hand, they are not a cure-all for
eliminating single or multiple accidents from mines, and with the installation
of closed lights there should also be the closest possible attention to insure
efficient ventilation, electrical equipment should be of permissible type and
kept in good repair and in so far as feasible electric arcing should be
eliminated from any place where methane might accumulate; only the safest and
most up-to-date blasting methods should be allowed, including use of
permissible explosives with electric firing and preferably all blasting in the
hands of shot-firers working after the regular shift; and by all means the most
stringent measures should be taken to exclude matches, smoking materials, or
other open lights from mines, and utmost care should be taken to use none but
permissible flame safety-lamps in testing for gas during the working shift.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Cash, Frank E. | | U.S. Bureau of Mines | |