14th July 1928, Page: 412, Column: 1
Dry Cleaning Of Coal
At the last general meeting of the South Staffs and Warwickshire Institute of
Mining Engineers, in the discussion of the paper by Mr. A. N. Harrison Slade
on "The Dry Cleaning of Coal," Mr. H. Mitcheson said
the paper would be most useful, as a statement of the different processes of
the dry-cleaning of coal, and especially comparing great with small plants. His
firm had erected one table on the glass-plate system on experimental lines. It
worked fairly well, although under different conditions in regard to the
quantity going over. It was sufficiently satisfactory to warrant them going
ahead, and they installed four tables to deal with the whole output of the size
they made. The tables were 4 feet 6 inches wide, and dealt with 200 tons in
eight hours, or about seven tons per table. The results were not all comparable
with wet-washing results. The separation was very rough, but they knew that
would be so when the system was installed. They started with common nuts,
containing about 18 or 19 per cent. of dirt, and the cleaned nuts had 8 or 9
per cent., and about 7 per cent. of ash. The dirt they took out contained about
10 per cent. of coal, and they were losing about 1 per cent. of the total coal
going over. They got an ash reduction of quite 10 per cent. What suggested
their taking up the process was the fact that it was very cheap, and they were
able to house it in the present screens, so that no special structure was
necessary. All they had to do was to install a 7-h.p. motor for blowing the
air, and a 10-h.p. motor for driving the tables. But they found in working it
was very essential not to overload. If they put too much coal over they got a
blockage and the coal fell through, and when that happened they had to clean
out and sweep the shutes, so they needed to keep somebody watching. They had a
limited quantity going over the tables. The men thought that three tables would
do the work, and he thought they would, if they could have maintained a
Wallingford feed. But they thought it cheaper to put in another table giving
them the extra capacity. Their coals were from three seams mixed together, and
they varied much as to hardness, and the mixture probably made it more
difficult from the cleaning point of view. The sizing must be pretty accurate.
If they got a large quantity of small going over the tables and the screen was
not working very well, which sometimes happened, they required to be swept.
Otherwise they required very little attention once they were set, and, on the
whole, they worked very satisfactorily.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Mitcheson, H. | | | |
| Slade, A. N. Harrison | | | |