2nd June 1928, Page: 357, Column: 2
Working Bullhurst Coal
Before the members of the North Staffordshire Institute of Mining Engineers,
Mr. John Cowcill presented a paper entitled "Description of the
Bullhurst Coal Seam and the Methods of Working the Same at the Rookery Colliery
of the Bignall Hill Colliery Co., Ltd., having Regard to Its Liability to
Spontaneous Combustion." Having described the method of working the normal
single Bullhurst seam, which is about 15 feet in thickness, he said Bullhurst
coal 30 feet thick has been successfully worked. This was done in two separate
workings or layers — the top layer first, after which the stoppings were
closed and made airtight. Headings were then driven to the far end of this same
area in the Bottom coal, and drifting back commenced in the same way as
previously explained. "In this second working," Mr. Cowcill
proceeded to say, "it had to be remembered that above the top portion of
this second layer of coal there was only the fallen-in goaf, and not a roof to
timber up to ; therefore, bond timber and good strong slabbing had to be used
more frequently even when drifting. Then, again, in these very thick areas the
seam is not always divided as in the normal single coal, namely, into Wall
coal, Middles, Little Tops, and Big Tops. The second 15 feet is therefore taken
in two layers, a parting being first made at 8 feet and then at 7 feet. In
drifting this last thickness of 7 feet only a very small hole has to be opened
out, and the coal and goaf slipped. This method, although at times a quantity
of dirt has to be removed, has been very successful, and very little coal has
been lost. At a later date it was discovered that there was an area with a
rearer fault on one side and a reverse fault on the other, in each case the
seam becoming normal at the bottom of the rearer fault and at the top of the
reverse fault. Between the two faults is a piece of coal which varies from 20
to 40 yards wide near the top and from 80 to 100 yards wide at the bottom; it
is several hundred yards in length, and at one place is at least 113 feet in
thickness. In two instances headings have been driven in the form of a zigzag
or winding staircase until the top portion has been reached, when heading-out
has commenced. Drifting back has been successfully carried on for the past two
years. Wherever a coal floor is left, it is covered with 6 inches of stone dust
before the timber is drawn in order that the roof dirt may fall. This stone
dust has a blanketing effect, prevents grinding and heating in the latter
stages of drifting the first or top layer, and forms an airtight joint when
working commences underneath for the extraction of the next layer of coal. By
this method of working, extending over a long period of time, it is expected
— and I believe we shall be successful — that the whole of the huge
thickness of Bullhurst coal will be got."
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Cowcill, John | | | |