5th May 1928, Page: 329, Column: 1
Quarrying By Well-Drill
By William Cullen, LL.D., M.Inst.M.M.
The following notes deal with a new method of quarrying or open-cast mining
which is likely to displace old and tried methods to a very considerable
extent. Although the notes deal with quarrying specifically, it is well to
remember that precisely the same methods as those described are in use to-day
in many metalliferous and diamond mines throughout the world. Quarrying by
well-drilling is not, however, capable of general adoption, for the
installation demands a considerable outlay of capital for plant for drilling,
mechanical handling, crushing and screening. Moreover, some of the rock
formations are quite unsuited for well-drilling — for instance, the
columnar formation, of which there are many examples in this country. Then,
again, it is quite unsuitable when the formation is broken and fractured, such
as is found at the Penlee Quarries in Cornwall and at many other places.
Nevertheless, there is considerable scope for the adoption of this method in
this country, and several installations are already at work — mainly in
lime quarries.
Without Cordeau Detonant or Cordeau as it is generally called, the process
could not possibly have reached its present state of development. It consists
of a lead tube, 0.23 inch in diameter, filled with very pure and uniform T.N.T.
in a finely-crystallized state. It is made by filling a fairly wide tube with
the T.N.T. and reducing this by passing it through rolls, in exactly the same
way as ordinary wire is reduced in diameter, by "drawing." The lead
must have a high ductility, and great care is taken in the drawing to see that
there are no air-spaces. Cordeau was invented in 1904 by a Frenchman called
Lheure, so that it is quite modern. Broadly speaking, the only practical
large-scale application to-day is its use in well-drilling. In this country,
however, a certain amount is used in holes made by percussive drills under
rather special conditions.
Cordeau is exceedingly safe to handle ; it stands a considerable amount of
rough usage, and cannot be readily ignited by a light of any kind.
Notwithstanding this, it is easily detonated by an ordinary detonator, and the
velocity of detonation is so very regular that it is generally used as the
standard against which the detonation velocities of high explosives are
measured in the so-called D'Autriche test. Its own velocity is from 16,000 to
17,000 feet per second.
How is Cordeau used in practice ? The free end on the reel is tied to or
threaded through one of the explosive cartridges, and with this cartridge
acting as a weight it is run off the reel to the bottom of the hole. The rest
of the charge is loaded and tamped in the usual manner, although a special
device for lowering the cartridges into position is required. The Cordeau is
next cut, leaving about 18 inches projecting out of the drilled hole to enable
connection to be made to the trunk-line.
A well-drill makes a hole from 4 to 8 inches in diameter, so that it will
readily be understood that the ordinary explosive cartridge to which we are
accustomed in this country is not of much use, and as a matter of fact
specially large cartridges, each weighing 5 pounds or more, are made for this
class of work. Some, indeed, weigh 16 2/3 pounds. The usual detonator for such
cartridges is 5 inches in diameter, and it is into one of these cartridges that
the Cordeau is threaded. Well-drill holes may be anything from 50 to 150 feet
deep, so that the problem of loading these holes is not so easy by any means,
for it is impossible simply to drop in cartridges and trust to luck. They might
jam before they had got properly started on their downward journey, and, of
course, there are other very obvious objections to this course. The difficulty,
however, is got over by a very simple device. Assuming the first 5-pound
cartridge to be in position, another is lowered down on top of it by means of a
line of light brass chain carrying an automatic release device actuated by a
pull on a second string.
Now in practice it is not found necessary to charge the hole With explosive
right up to the top. Tamping in the form of loose earth or clay can be
interspersed — preferably at those points where the formation is not
quite so resistant — for a very careful log is kept of each hole. The
fact of the Cordeau, however, stretching from the bottom right to the top
ensures that all the explosive is detonated, which would not be the case with
the ordinary fuse and detonator unless each section of the charge had its own
separate detonator, which would be difficult if not impossible to arrange in
cases where a large number of shots had to be fired. The great advantage of
this method is that the charge can be placed where it is more required, and
this in return makes certain of good fragmentation.
The most common system of quarrying where big masses of material have to be
moved is to excavate a chamber or chambers about the base of the face and fill
these up with explosive, which is set off in the usual manner. In the case of a
face 100 feet deep, however, it is perfectly evident that at the surface, i.e.,
100 feet away from the seat of the explosion, the explosion effect will in all
likelihood be quite secondary, and huge masses of material may be merely
loosened and not broken. These will require secondary blasting, which means
additional cost. So far as can be judged the effects of blasting by charging up
well-drilled holes in the manner indicated leads to much more regular
fragmentation — an effect which would almost be predicted. The benefits
of well-drilling are thus indirect, but none the less tangible. Supposing,
therefore, we had a face 50 to 100 feet deep, we would start to lay out the
holes about 20 feet back from the face and about 20 feet apart from one
another. These holes would be drilled up to any number, and this work would
take several weeks if not months, depending upon the equipment. When the blast
took place, enough stone might be brought down to satisfy the rest of the plant
for many months, but this is just where experience and management come in.
When ordinary nitro-glycerine has an admixture of from 15 to 20 per cent. of
either polymerized nitro-glycerine or of dinitro ethylene glycol, it will
withstand freezing in the coldest British climate we are ever likely to have,
and, as a matter of fact, it has withstood the temperatures which were obtained
in the Seaham shafts when they were being sunk by the freezing process. Both
Cordeau and non-freezing explosives have contributed very largely to the
success of well-drilling, although under favourable conditions it was, of
course, quite possible to carry on this operation without non-freezing
explosives.
* Excerpts from paper (Some Notes on Quarrying by the Well-drill Method)
prepared for meeting of the North of England Institute of Mining and Mechanical
Engineers on 21st April.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Cullen, William | | Mining Engineer | |
| Lheure, — | | | |