25th February 1928, Page: 251, Column: 1
Retort Oil Yields
Two ideas underlying the preparation by Mr. Charles Turner of his paper
on "A Process of Low Temperature Carbonisation" for presentation at
the February meeting of the Manchester Geological and Mining Society were
— to present some of the thoughts which induced him to design and later
to build his retort at Poynton, near Manchester, and to describe the plant at
Coalburn, Lanarkshire, together with a brief account of the work done by it. In
the Poynton retort he treated 32 different materials, comprising peats,
lignites, oil shales, cannel coals and bituminous coals. Only the last class
provided any difficulties. Some of them swelled so much that three months after
starting work he ordered a new retort body to be made with the biggest taper
possible of being fitted between the hoppers above and below it. At the same
time, he put in a new and flatter archimedean screw, because the residue from a
Far-eastern lignite would not rest on the old one. No difficulties were
experienced with the new screw, but, whilst a great improvement on the
original, the new retort did not obviate all the difficulties of treating,
satisfactorily, such coals as become very plastic when heated, or, as the
workmen called them, "the coals which melt." These prevent the steam
from penetrating the mass quickly, and so take very much longer to treat. The
worst examples of such coals required to be treated for 12 hours in the retort,
whilst the best of the non-melting coals required only 2 hours, the particles
of raw coal being of similar size in each case. So far as Mr. Turner is
aware, the best working conditions can be determined only by trial. The yield
of oil in gallons per ton of material treated at Poynton varied for peats up to
20, for lignites up to 60, for oil shales up to 80, for cannels up to 35, and
for bituminous coals up to 45. For instance, treated with steam at 400° C.
one oil shale left a residue containing less than 1.5 per cent. of
volatilizable matter, whilst another was changed only into a crude bitumen.
With steam at 410° C. the former set up a gas reaction, whereas no gas, as
distinct from oil vapours, was produced from the latter with steam up to
600° C.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Turner, Charles | | | |