|
11th February 1928, Page: 234, Column: 1 Lighting Power Of Safety-LampsConsiderable importance is attached to increasing the lighting power of miners' safety-lamps for the efficiency and comfort of the miner, and as a preventive measure against miners' nystagmus. The maximum lighting power of the present-day flame safety-lamps is about 1-2 candle-power, but a large proportion of them give little more than half a candle-power. Investigations described in the Safety in Mines Research Board's Paper No. 40, "The lighting power of flame safety-lamps," by R. V. Wheeler and D. W. Woodhead (H.M. Stationery Office, price 1s.), show that a remarkable increase in lighting power can be obtained by regulating the height of the gauzes, by careful selection and blending of oils, and by other small modifications. The flame lamps considered are those most commonly in use in this country, burning oil or "spirit" (oil of low flash-point). The majority of the flame safety-lamps in use at present are included in the three general types "Marsaut," "Wolf" and "Combustion-Tube." The principal lamps used for the experimental work are : (A) The "Prestwich Protector," a lamp of the Marsaut type burning spirit; (B) the "Davis-Kirkby," a lamp of the Marsaut type, burning oil; (C) the "Premier Fig, 7," a lamp of the Wolf type, burning spirit; and (D) the "Hailwood," a Combustion-Tube lamp, burning oil. The "Mueseler" lamp in its simplest form is but little used nowadays and has not been considered. The Combustion-Tube type of lamp can be regarded as a Mueseler lamp with a glass extension of the chimney. The lighting power of flame safety-lamps is dependent on the character of the fuel used in them, as well as on their construction. The general scheme of the investigation recorded in this paper was : (I) To determine the extent to which variations in the character of the oils used in typical lamps as ordinarily constructed affected the light given by them, so that the most satisfactory oil, or blend of oils, to use could be specified. (II) To study in detail the effect on the light-giving power of a lamp, of varying its more important dimensions. The following summary of results is given:— Fuel. — With oil-lamps of the Marsaut type, a ternary blend of one part by volume of a petroleum spirit of specific gravity not less than 0.72 (at 15°C.) with seven parts of a 1 : 7 mixture of paraffin and mineral colza has been found to give the highest candle-power, an increase of 35 to 40 per cent. above that given by mineral colza alone being obtained. Where the conditions of use of oil-lamps are such that smoking tendencies may be induced, the use of a blend of one part of vegetable colza (rape-seed oil) with seven parts of mineral colza will be helpful. With lamps in which the ventilation is directed close to the flame, such as in the combustion-tube lamps, the blend of oil used is not so important, but it is desirable that the oil should have a high specific gravity (greater than 0.83). With spirit-lamps the fuel should be of low specific gravity (about 0.72) and short boiling-range (about 10°C). Burners. — Enclosed burners are recommended for oil-lamps. They are, indeed, essential if the full advantage of the use of the ternary blend of oils recommended is to be obtained. Enhanced candle-powers are obtained if a concave cut is given to the wick-tube, the wick itself being also cut, or allowed to become, concave. In lamps that are only required for use during a few hours, still higher candle-powers can be obtained by use of convex-cut wick-tubes, the wick being straight-cut. The material of the wick-tube is of no importance. Spirit-lamp burners should be provided with sealed caps. Wicks. — Higher candle-powers are obtainable from an oil-lamp by use of wick (so-called "spirit" wick) of about half the usual thickness. This is particularly advantageous with combustion-tube lamps. When an oil of high viscosity, such as a blend of vegetable colza and mineral colza, is used, a soft wick is to be recommended. Gauzes. — Reasons are advanced for believing that the maximum candle-power obtainable from an ordinary Marsaut lamp (burning either oil or spirit) is about 1.45. It is suggested that this candle-power be obtained from a properly-designed and proportioned Marsaut lamp, burning the most suitable blend of oil or quality of spirit and fitted with the most suitable wick, with 28-mesh gauzes, and that the use of 20-mesh gauzes, although improving the less efficient types of Marsaut lamps, is of no advantage to such a lamp. With combustion-tube lamps, on the other hand, the use of 20-mesh gauzes is advantageous. The highest candle-power obtained with a lamp of normal dimensions has been with a combustion-tube lamp fitted with "spirit" wick and 20-mesh gauzes, burning a blend of paraffin and mineral colza of high specific gravity. The value was 2.5 candles. Marsaut Lamps. — An important dimension with respect to the candle-power of the Marsaut lamp is the height of the gauzes. With many of this type of lamp at present in use the gauzes are too short. With properly-proportioned gauzes (of 28-mesh), and when burning a blend of oils, a candle-power as high as 1.45 could be obtained from the Marsaut lamp, whereas a large proportion of those in use give no more than 0.5 to 0.6 candle (increased to about 0.85 by the use of 20-mesh gauzes). Beyond a certain height of gauze (about 6 inches), no further increase in candle-power is obtained, but, on the contrary, the flame begins to flicker owing to the ventilation system within the lamp becoming unstable. The higher the lighting efficiency of the lamp as determined by the length of the gauzes, the less liability is there for the flame to smoke, the clearer does the glass remain during continued burning of the lamp, and the cooler is the lamp-base. Wolf Lamps. — With lamps of the Wolf type, designed to receive air both through a middle ring and below the flame, the highest candle-power (2.23) was obtained when all the air entered below the flame (although the flame was then rather sensitive to sudden air-currents), the gauzes being 5¾ inches long and of 20-mesh. Combustion-tube Lamps. — The candle-power and the temperature of the lamp-base of the combustion-tube lamp are dependent mainly on the height of the gauzes. With gauzes (of 20-mesh) 5¾ inches long, a candle-power of 2.75 was obtained from a combustion-tube lamp, the lamp-base remaining lower in temperature than that of a similar lamp with shorter gauzes giving 1.20 candle-power. An important adjustment in this lamp is the distance between the burner and the platform supporting the combustion-tube.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||