28th January 1928, Page: 219, Column: 1
Wigan Four-Feet Seam
The Fuel Research Board has issued "Physical and Chemical Survey of the
National Coal Resources No. 10 — The Lancashire Coalfield : The Wigan
Four-feet Seam." (H.M. Stationery Office, 3s. net.) The seam dealt with is
known over a considerable area around Wigan, where it is well developed, as the
Wigan Four-feet Seam, but in other parts of the field it receives different
names. On the Eastern side of the South Lancashire Coalfield the names Hell
Hole, Ell Hole, and variations of these, are used : thus around Walkden,
Kearsiey and Bolton the seam is called the Hill Hole or Hell Hole ; at Worsley,
the Hell Hole or Ellel; and at Astley the Hello. At Pendlebury it is called the
Victoria. Around Atherton the seam is known as the Four-feet, and at Hindley
Green the Hindley Green Four-feet. In the west of the coalfield the
nomenclature of the seam is very confused, and correlation is difficult. In the
St. Helens district there are two seams, together known as the Bastions Delf,
lying near this horizon. The upper, or Bastion Tops, is regarded as the
equivalent of the Wigan Four-Feet seam, while the lower, called the Bastion
Bottoms, or Roger, corresponds to the Trencherbone seam. At Prescot, on the
extreme west of the coalfield, the two portions of the Bastions Delf are
separated only by a dirt parting.
Following details of the seam found in the various districts, the following
summary and conclusions are presented :—
1. The Wigan Four-feet seam, or its equivalent, though of universal occurrence
throughout the South Lancashire Coalfield, has not been correlated with any
seam in either the Burnley or the Manchester Coalfield. Over the whole area in
which the seam is known to occur it is of good quality, consisting of fairly
hard and moderately bright coal containing a certain amount of durain. It is
seldom split by thick shale or dirt bands, but numerous thin streaks of shale
sometimes occur in the upper part of the seam. The thickness varies with
considerable regularity from about 2 feet on the east of the coalfield to a
maximum of 6 feet 3 inches at Garswood, thinning slightly from this point
towards the St. Helens district. The Wigan Four-feet seam yields a good coking
coal, and is used chiefly as a house or as a gas coal; it produces a coke which
is usually only slightly swollen.
2. Referring to the table of proximate analyses of the "whole-seam"
samples the moisture figures are about normal for this type of Lancashire coal,
except in the case of the Garswood sample, in which the moisture is high. The
ash-content is more variable (from 2.6 to 9.9 per cent.) but on the whole is
low, the average lying between 3 and 4 per cent. The volatile matter is high,
the average being about 40 per cent. on the dry ash-free basis, but a fairly
large variation (between 34.7 and 43.3 per cent.) occurs in the figures from
the various sections. Except in the sample from the Outwood district, the coke
buttons obtained from the proximate analyses were strong ; the amount of
swelling varied considerably.
3. The carbon and hydrogen contents are high for this class of coal. The carbon
in the dry coal reaches a maximum of 86.24 per cent. at Leigh, where the
hydrogen figure is also high. The maximum hydrogen content is 5.49 per cent.,
recorded for the Clifton sample. The amount of nitrogen present in the seam
ranges from 1.49 to 1.97 per cent. on the dry coal; the latter figure is high.
The sulphur content tends to be high in the Tyldesley and Atherton districts,
but elsewhere is comparatively low. The percentage of phosphorus, though
variable, is never high enough to be of serious moment. The maximum amount
recorded is 0.0304 per cent. (in coal) in the sample from the Garswood
district.
4. In all the districts from which sections were examined the seam possesses a
fairly high calorific value, the figures lying between 13,160 B.Th.U. per lb.
at Golborne and 14,340 B.Th.U. per lb. at Ince.
5. Laboratory carbonisation assays were carried out in the Gray-King apparatus,
using samples representing the whole seam from each of the districts dealt
with, with the exception of Clifton and Golborne. In general, the cokes
produced were only slightly swollen, or non-swollen, hard, and strong, and the
yields of gas, tar and liquor were moderately high. The sample from the Outwood
district behaved differently from the others ; the coke produced was weak, the
tar yield low, and that of liquor high. The difference is due, in part at
least, to oxidation of the coal face, owing to its not having been worked for a
considerable time in the colliery from which the sample was obtained. The
results of the assays, with the exception of that of the Outwood sample, point
to the suitability of the Wigan Four-feet coal for gas manufacture.
6. Considerable variation is evident in the melting-points, determined in air,
of the ash from different localities, the extremes being 1,270° C. at
Kearsley and over 1,400° C. at Bryn. When determined in a reducing
atmosphere, however, the melting-points fall within narrower limits.
7. The caking index of the seam, given by the method described by M. Barash,
varies between 3 (Outwood section) and 15 (Leigh section). The
highest figures were obtained from sections taken near the centre of the
coalfield. The low figure for the Outwood section is due to oxidation.
8. Washing tests were made npon samples of the coal obtained from the Atherton,
Leigh and Garswood districts. The results show that the coal lends itself to
purification by both float-and-sink and froth-flotation methods, although
difficulty might be experienced in obtaining a high efficiency with the coal
from the Atherton district, owing to the large amount of "middles."
9. The Wigan Four-feet seam is to be regarded as a valuable asset to the South
Lancashire Coalfield. It is at present being raised from several collieries,
mostly situated in districts where the development is good. In those areas
where the seam is thin, it will receive more attention and become increasingly
valuable as the thicker seams approach exhaustion.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Barash, M. | | | |