|
28th January 1928, Page: 213, Column: 2 Lamp-Room PhotometersA short paper on "Demonstrations with a Lamp-room Photometer" was presented by Dr. J. S. Haldane and Dr. R. V. Wheeler, at the 38th annual meeting of the Institution of Mining Engineers. The shadow principle is employed in the lamp-room photometer discussed, the shadows produced by a standard candle and by the lamp under test being projected side by side and just touching one another on an opaque white surface. By sliding the lamp along a scale graduated in terms of the square-root of the distance from the screen, unity being the distance at which the shadows are equal in depth if the lamp is throwing on the surface a light equal to that thrown by the candle, the relative illuminations produced on the surface by the lamp and the candle are measured. The scale, which is 4 feet in length, enables illuminations from 0.15 to 4 candle-power to be measured. To measure higher illuminations, up to 16 candle-power, the standard candle is shifted to a position half the distance from the illuminated surface ; and for illuminations up to 64 candle-power, the distance of the candle is again reduced to half. This gives a range sufficient for all practical mining purposes. Special arrangements for bringing the candle-flame to the same level as that of the lamp-flame or filament are also provided ; and the form of the standard candle is such that it can easily be raised or lowered to suit the lamp. The standard candle must be lighted a few minutes before it is used, as otherwise it does not give its full light. The standard candles provided are specially made so as to give as nearly as possible the same light as that given by the Harcourt 10-candle petane lamp, which is now the primary measure of illuminating-power. The light given by such a standard candle is not perfectly constant; but in measurements of the different lighting duties of lamps used underground, errors due to slight variations up to 5 per cent. in the standard flame, or still greater errors due to rapidity and roughness in the actual measurements, are of hardly any practical importance. The difference in visibility produced by a difference of 10 per cent. in actual illumination underground is barely appreciable. It is only much greater differences than this that are worth measuring. When an electric lamp and flame-lamp are compared, the shadows have different colours. It is easy, however, to estimate the difference in depth of shadow, irrespective of its colour. When a lamp with a flat flame, or electrically-heated filament, is being examined, it is well to have the flame or filament at an angle of about 45° to the illuminated surface, since the illumination is considerably greater with the flame or filament flatwise than edgewise. A lamp provided with a reflector or lens should be examined while it is pointing at different angles, so as to get some idea of the angle over which the lamp gives fair illumination. Unless this angle is a wide one, the lamp is not very satisfactory for ordinary purposes.
|
|||||||||||||||||||
![]() |
||||||||
|
Mail: Webmaster |
Back |
Home |
Copyright © 1999-2024 by The Durham Mining Museum and its contributors Registered Charity No: 1110608 Page last updated: 28 Nov 2022
|
Search |
|
|||