31st December 1927, Page: 186, Column: 1
Cleaning And Sorting Of Coal*
By E. P. Shore.
Section 82 (1) of the Coal Mines Act requires that no plant for the screening
or sorting of coal shall be situated within a distance of eighty yards from the
downcast shaft, and this means that we have to deal with the tubs over this
length of rail. There must be well laid and evenly graded roads on this length.
If we are unloading the cage on the ground level we shall have to get the coal
down or up so as to weigh it on one level if we have two or three decks to a
cage. If the natural slope of the surface does not allow sufficient height for
the screening plant, some means must be employed to get the tubs up to the
required height. This is generally done by creeper chains driven by electric
motors. If the pit top has been built above the ground level we may have to use
a similar chain, but working in the opposite direction, and this is then known
as a retarder ; or a balanced cage or cages can be used. Having got the loaded
tubs on to the tippler floor of the screening plant, the tippler is driven by
friction wheels from its rim, and these are operated by a motor under this
floor which also drives the screen and belts. The tubs are turned over and
deliver the coal on to the shaking screen, which is a steel frame built up and
covered on the bottom with steel plates with suitable perforations, round or
rectangular and of such sizes as it is thought desirable and suitable for trade
purposes. The screening can also be done by a Chambers' vibrating screen, or by
a "Zimmer" method of conveyor belt and screen.
In the arrangement of tippler, screen, belt, and delivery into wagons, we must
bear in mind the necessity of making each change by as small a fall as
possible, and at the ends of belts a portion is now usually arranged and
pivoted or hinged and fitted with suitable friction gear to be lowered into the
bottom of the wagons, and raised as the wagon fills. Wagons should be carefully
loaded to their fullest capacity, and the large pieces be safely placed for
rapid railway transit as well as for the sake of appearances.
The difficulties which have been met with in the screening of small coal have
produced many systems of washing for the purpose, and in all practical systems
gravity is the agent used to bring about the separation. At some collieries the
output may contain 40 per cent. of the grades or sizes which are too small to
be hand picked, and often in excess of 20 per cent. dirt. So large a quantity
of dirt must be got rid of to make the coal marketable, or we shall find it on
our hands preventing the production of the larger coal for which there may be a
good demand. The ash content of the small coal fixes its market value, and it
is generally recognised that if the ash in the smalls exceeds 10 per cent,
washing should be considered.
It is not easy to give actual figures of the cost of washing, but items which
regulate this to a great extent are : (1) Power and labour to convey slack to
washer ; (2) power and labour required for working plant ; (3) power and labour
for refuse disposal; (4) reduction or loss in quantity if plant is inefficient;
(5) labour in loading and handling wagons ; (6) interest on capital outlay; (7)
depreciation of plant; (8) renewals and replacements, which are very important.
The difference of price obtainable for the washed products can be gauged, and a
balance of earning capacity arrived at.
The washing plant should be arranged to stand as near to the screening plant as
possible. Plants most generally used are: (1) The system of sizing before
washing, and providing separate washing boxes for each size, the pulsation of
the water being produced by plungers (Shepherd, Luhrig, Humboldt). (2) The
system of washing the slack in one large box with air valves for water
pulsation, and grading and sizing after washing (Baum, Greaves, etc.). (3) The
latest introduced into this country is known as the Rheolaver, or current
classifier, with upward water jets. It is used in France and Belgium, the claim
being that it is simple with few working parts.
In the plunger type of washer it is necessary to arrange inlets, and outlet
gates, for discharging the dirt; also it is necessary to introduce a flow of
water across the top of the tank or box so that the raw coal or slack can be
regulated on to the box at one end and the light clean coal discharged at the
other end, whilst the dirt escapes underneath at each end. This system is said
to have a great drawback owing to the suction caused by the upstroke of the
plunger through the bed of coal, thereby causing the coal and dirt to descend
with equal velocity, and sucking the finer particles of coal through the plate
to lose this coal in the dirt below. Feldspar was introduced into the boxes to
counteract this, and is used to-day in the boxes for washing the very fine
coal.
Baum conceived the idea of using compressed air admitted in pulsations instead
of the plunger to give the necessary jigging motion to the water. The
pulsations are controlled by piston valves, and it is a simple matter to
control the inlets and cutoff of the air and exhaust as required, and also to
get a cushioning effect and reduce the suction on the bed of dirt and coal. It
has also been found by using this method that the ratio of sizes of separable
particles has been greatly increased, so that washing before classifying was
made possible. The coal, after leaving the box in this system, must be
classified into the various sizes suitable for the market, and for this purpose
we may use either vibrating screens or revolving drums, each size being carried
away in troughs to the several bunkers for storage and further drainage. As
they are being delivered to the bunkers a draining sieve or plates must be
provided to take all surplus water out, and at this point a good clean water
spray is very necessary to take off any slime which would spoil their
appearance on drying. Re-washing has been found to be very necessary if the
coal is to be used for coking, and it is improved for industrial purposes also,
for we know that it is as clean as possible. A difficult problem arises in the,
draining and drying of the small product; to be considered successful the
moisture content should not be more than 9 per cent., and if it can be reduced
it is all the better for coking and sales. Briefly, the centrifugal dryer has
been used in several cases, but it is very costly to install and uses a large
amount of power. It may also be found to be inefficient as we must arrange for
perforations or sieves which allow too much of the very fines to escape with
the water to make the drying successful. Capacity is a further difficulty. A
good range of storage bunkers is as good as anything tried up to the present,
and if large and numerous enough to allow the washed smalls to stand and drain
for at least 48 hours before using or loading, they make a great difference to
the moisture content.
The Rheolaver washery depends on the separation of the coal and dirt taking
place as it passes along a trough with the flow of water, the trough being
provided at intervals with outlets from which the dirt can be extracted. At
these outlets an upward jet of water is applied to prevent loss of coal with
the dirt. These outlets are numerous and appear to require considerable
attention, especially if the supply of raw coal varies very much.
Dry separation methods are being introduced into this country. One of them, an
American invention, is worked by means of spirally constructed chutes. It can
be used down to about ¼-inch sized coal and is known as the Pardee spiral
separator. The very small coal which is difficult to wash is left out in this
system. One of the latest systems is the pneumatic separator, known as the
Sutton-Steele process. A further very essential feature is the fixing of an
effective dust extracting plant.
Regarding the disposal of the dirt or refuse from the screens and washer, all
the dirt from belts or screens can be collected and deposited on to one belt
discharging into a hopper, and the simplest scheme (not requiring a large
capital outlay) is to fix up a ropeway which can be so arranged as to be able
to load from the dry dirt hopper as well as from a separate wet dirt hopper for
the dirt from the washers. It will be found that this method will deal with the
refuse at a reasonable cost in labour.
* Excerpts from recently-delivered paper on "From Pit Top to Wagon, or
Banking and Screening, or Cleaning of Coal," by Mr. E. P. Shore,
Engineer at Brodsworth Colliery, before the Batley and District Mining Society.
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Shore, E. P. | | Engineer | |