5th November 1927, Page: 122, Column: 1
Gold Mining In Wales
The now president of the South African Institution of Engineers is
Mr. Frank G. A. Roberts, and in his presidential address he made an interesting
reference to an ancient mining proposition in the Principality as follows :
"During one of my trips to Great Britain I was asked to look at a gold
mining proposition in Wales which had been worked by the Romans, or perhaps it
would be more accurate to say worked under Roman stimulation. This proposition
was interesting in many respects, and sufficient remains had been found to set
the matter of Roman connection beyond all doubt. There was evidence of a water
furrow of considerable size having been cut for a distance, I think, of some
seven miles, in order to lead water to the top of the hills in which the
property was situated, and there were many other signs of ancient and sustained
activity, including numerous debris or tailings heaps, all, of course, long
since completely covered by soil, grass and trees. The tailings consisted
mostly of quartz crushed to about the size of a small pea, and I was told that
it was rare for any free gold to be found in them, or for them to assay more
than about one dwt. The metallurgists of those days, therefore, apparently knew
their job.
"The ancient workings were, I believe, mostly open cast, but this is
difficult to say with any degree of certainty because of the results of work in
more recent years. In at least one place, however, the ancient workings were
underground, as came to be discovered by the comparatively recent cleaning out
of what proved to be the mouth of an old adit. This old adit was nearly
rectangular in section, about 3 ft. 6 in. wide and a little over 4 feet high.
It was driven into the side of a high hill for a distance of 100 or more feet,
where it struck the reef. At the entrance it was almost flat, but within a few
feet it steepened to an angle of about ten degrees plus, and at the end to a
slightly greater angle. The floor of the adit had been worn smooth, obviously
by the transport of ore on a sleigh, and it is interesting to realise that the
engineers of those days must have calculated the angles to suit sleigh
conditions in much the same way as we now adopt a rise of say one in two
hundred to suit a one man power ton track on roller bearings. The adit was
driven in only moderately soft schistose rock, and when I saw it, about 18
years ago, the sharp triangular marks of the tools with which it had been made
were still distinctly visible. These marks were so regular and numerous that I
assume them to have been made by something in the nature of a gad, or what we
here call a sampler's chisel, and not With a pick. The workings at the end of
the adit had mostly fallen in, but from what I saw of them, and indeed from
what I have seen of other old workings, especially in Northern Italy, these old
predecessors of ours required no lessons from us in the matter of narrow
stoping widths, or what is really a more accurate term, 'clean mining.' In fact
the boot is rather on the other foot."
 |
 |
|
Names mentioned in this article
|
 |
 |
| Name | Age | Occupation | Notes |
| Roberts, Frank G. A. | | President | |